The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hi. We had weird problem. - vManage, vSmart, vBond : 20.9.4 (Manage 20.9.4.1) - C1111-4P SD-WAN Mode : 17.9.4a Only 3 traffic go to SIG by traffic policy (O365, Webex, Windows Update) But one of our custom application which was defined as a inter...
Last week I offered my students a test in PacketTracer.Part of the assessment was a topology with three 2960 L2 switches, where S2 was configured as VTP server, distributing vlan 10,20,30 and 40. S1 and S3 configured as VTP client.Links between the s...
Hi all, noob here pls don't be too harsh.I have a kind of a small business setup with about 20 workstations and a physical server with some (yet unidentified) virtual machines.Domain controller is not some local sever, it is cloud-based: MS Entra ID ...
hi everyone, We are implementing a project and will integrate ACI with VMware NSX. I have a question: when integrating APIC with VMware NSX, is it necessary to first integrate with vCenter so that APIC automatically creates VDS, and then Integrate wi...
I learning how to set-up firewall and came accross such a problem when trying to connect through web-browser to DMZSERV : 3. The packet is coming from an outside network. The device looks up its NAT table for necessary translations. 4. The packet is ...
Hi everyone, Currently, I've been using the Interface NAT type for Direct Internet Access (DIA) across multiple networks. However, I recently came across a Cisco article (Below link) suggesting the utilization of a Loopback interface for DIA ins...
IP Helper-addres for VLANsThis is simple solution to reduce a bottle neck of router which is issuing ip address to clients using IP DHCP pool "Vlanxx". IP Helper-Address command can point to enterprize DHCP Server instead to issues ip address to thei...
Hello, I am very new to networking and I am currently trying to set up a lab in my computer science class. I am trying to set a forward lookup zone to our parent network's DNS server. When doing so the request says "A timeout occurred during validati...
Hello,Both the Grammarly and ChatGPT sites are accessible, however, the WSA will not allow us to use the them properly. In the case of ChatGPT, if you try to open a document, the error shown is, "Can't connect to Grammarly. your network configuration...
Hello everyone,Here i have two uplink from my main core switch which is connected to Main-R.i would like to utilize both uplink same time for different network Eg:MGMT network use Service Provider as a Uplink (192.168.3.2)DATA network use Main-R as a...
hi all,Thanks for your reply!physical topology is very simple: core switch stack (2x WS-C6506-E) connects to access switch via port-channel, no more redundant link. I see lots of topology change logged from core switch, for example:Number of topology...
Hi AllI've inherited a newtwork that includes the C3850 and we've installed the C2960X. These are hooked up via copper ethernet and have a very simple configurationC3850 interface GigabitEthernet2/0/2 description Uplink to C2960X switchport mode tr...
Our MSP recommends the DNA Essentials license. I've recently taken over and it's been renewed a few times. I see this is for Catalyst Center? I'm looking into how I can use Catalyst Center to see if it's worth it, (we're a small shop with 6 stack and...