Greetings, I'm creating a system that requires a TAA(Trade Agreement Act)-compliant switch be used. I have a SG500X-48p, SN: DNI181602C0. How can I verify whether the device is TAA compliant? Thanks in advance for any responses.
The management function of 240ac Wifi accesspoints does periodic radius requests with a user named "cisco-probe". Part of "Active Fallback" radius mode.Currently these requests fail, and fill up my logs.Which password does this "cisco-probe" user hav...
This is related to a previous issue I posted here "titled issue-getting reply traffic back from our cbs 350 switches".I have three VLANs defined on our CBS350 switches and sub-interfaces configured on our router (PaloAlto firewall) with all policies ...
I have tried multiple instructions on resetting this switch (Cisco 2960L-24PS-LL), but nothing I do works.I have held the MODE button while powering on the switch for various intervals (from 15 seconds all the way up to 2 minutes)I can access the con...
Hi I have an SG500-28P that is behaving oddly. Factory Reset via button on the front took ages to respond, I have been told 10 seconds or above and it should flash all lights and reboot. It does not. Finally got it to reboot and now it goes through t...
Hi there,We have recently installed a Cisco Webex Room Bar Model: CON-ECDN-CSBARMPN. We seem to be having an issue getting audio out from the sound bar. We can see the camera & the microphone but no speaker. The navigator is been used for BYOD only a...
I just purchased a Cisco CBS250-24P-4G 24 Port Smart Switch with the intention to mount it in a rack. The unit came with a mounting kit but the brackets force the switch to stick out more than an inch.Are there brackets that enable a flush mount so t...
Hello, what are "non-XG" devices that are referenced in the manual like in the screenshot i posted? I have a CBS250-24P-4X switch, does the "X" mean it's an "XG" device?
I'm looking for a way to get MAC addresses on a specific port that doesn't include all possible ports.For example, I want all mac addresses listed on port Gi1/0/2. I don't want MAC addresses listed for ports 20-29, just 2. "sh mac add | i Gi1/0/2" d...
I upgraded the firmware on my Cisco 350-28 Managed switch to the latest (2.5.9.54). After it rebooted, I was no longer able to log into it with the credentials which formerly worked. It is working fine, and everyone on my LAN has internet access, b...
We have irregular problems with passwords on Cisco SG250/SG350/CBS250 devices – more precisely with password changes. We suspect that it might be perhaps due to special characters in the password. Possibly "only" the web GUI is affected and not the S...