Cisco Catalyst Center

Hey all, I attempted to upgrade from 1.2.0.1021 to 1.3.0.115 and the operation in the GUI times out and reverts back to the dashboard after a few minutes. Maglev reports this error message when I attempt to do anything in CLI. ERROR:requests.packages...

Sharing a recent experience we encountered while upgrading our DNAC cluster. Our upgrade was from 1.3.1.3 directly to 1.3.3.4. The error we were seeing in the maintenance UI was specifically: Phase:Node x.x.x.x - Backup NFS server mount failed The CL...

Hi GuysWe facing a question that regarding of SDA solution that how to enable pxGrid service on ISE node to integrating with DNAC,  As cisco docs indicated that to enable pxGrid service should be subs plus license for ISE , the existing ISE just had ...

I'm trying to configure the switches in my campus fabric but I cannot push the configuration through DNA, even I have configured the SNMP, CLI, SSH username and password and assign all of these to the site but still can't push the configuration, Also...

My Cisco partner sent me a quote of DNAC1 Essentials and DNAC1 Advantage Term for a Catalyst 4500E 10 slot. I only have one Catalyst 4500E but has two supervisors.-This two supervisors is the reason why they are sending me a quote for DNAC1 Essential...

We have a deployment we cant really figure out why we cant create the actual Fabric. Under Provision, we only have devices and services, not fabric. All software packages are installed (SD-access is "Ready"), but still no Fabric-tab. Any clues? We ar...

I have been testing applying on-boarding templates to switches during the LAN automation process with no luck. I have also tried Day N templates after the device has been provisioned with no luck.  I am not sure if this functionality is there yet or ...

A question came up as to whether or not any additional or special licensing was required simply to activate the M12PQ module or 40G ports.  Can anyone definitively answer this?

We have a deployment we cant really figure out why we cant create the actual Fabric. Under Provision, we only have devices and services, not fabric. All software packages are installed (SD-access is "Ready"), but still no Fabric-tab. Any clues? We ar...

I want to isolate a device in a VN. Which means, I want a policy SRC: SecurityGroup DST: any CONTRACT: deny. But as far as I can stell, there is know "any"-Group? How do you isolate a SG in DNAC?

Hello Community,IS it feasible to configure for DNAC as DHCP , if configured what will be impact (or) any future issue with DNAC with DHCP Server.is anyone applied this setup in their environment ?Needful suggestion would be highly appreciated.