Cisco Catalyst Center

Hello, i work at a university and we run all cisco switches and routers for the university in our datacenter on prem. Recently we had a bad storm that took caused a power surge and took out 1 switch. We managed to recover by rebooting the switch, how...

Hello All,We're running into an issue here with DNA Center Device Replacement for Industrial Ethernet switches. These switches are extended nodes as part of a larger SDA fabric, though I'm not sure how much of a factor that is.The problem is that whe...

Hi all,Is it possible to adjust the Client Connectivity Score values? For instance, adjust the RSSI from the default -72dBm to -67dBm.Thanks. Kind regards,Vasco

Has anyone figured out a way to stop a task in progress within DNA center? i.e. deploying software image to switch across WAN circuit and realize this should be done during non business hours to preserve bandwidth.

I can either add a new physical switch to an existing stack in dnac and then do a resync or provision on the cli of the switch in advance of adding the new member and then resync in dnac. At which point dnac becomes aware that stack has a new member....

Hi. After upgrading DNA Center to 2.1.2.7, there is a discrepancy between the access interface configuration for my switches. After provisioning a LAN Automated switch and making it fabric enabled, I would expect the following configuration on my acc...

Helloi have a question, is it best practice for both fusion router and Border node in stacks ? because in document how to configure fusion router for the border and fusion are different logic  thank you

Hello Cisco community, I have a question regarding the DNA Center which is the following : If a switch is managed by DNAC through NETCONF, when I change the switche's configuration manually through CLI (for erxample adding a VLAN), can I use the "res...

Good morning all,Can you use DNAC to archive your network devices configurations? Hope you all are staying safe.

Hi Gents, Can I start the cisco SDA setup with a single DNAC  DN2-HW-APL node for production and add the remaining 2xDN2-HW-APL server after the installation is complete, maybe after a few months ? and is there any limitation (some functions need a f...

Hi,I have configured compliance policy which controls "authentication open" under access mode interface. In violation message i can gather interface id by typing <1.1> (first output of first regular expression). Now i also want to gather interface de...

Hello Cisco, Does anyone know the ETA the DNAC on-prem Virtual Appliance release? https://blogs.cisco.com/networking/deployment-options-expand-with-new-cisco-dna-center-virtual-appliance-2 Thanks