Cisco Software Discussions

Hi All,  i am getting below notifications from ISE, could some on advise what action i should take against it. if so where i could find and update it. if the below mentioned needs attention. "Your network access password will expire on Sun Apr 04 10:...

i able to configure pppoe and i get wan ip but my lan can't get access to internet although i can ping wan ip my router can access the internet but i can't ping  my wan ip from my router here is my configurationCurrent configuration : 1356 bytes ! ! ...

Hi all, Does SmartNET for software covered license transferring? Thanks,Hafiz

 Hi Everybody, I have installed the followingUCCX: 12.5.1.11001-348SocialMinor: 12.0(1)-37 After I configure the CCP Configuration in UCCX, with socialMinor IPit shows the following error Unable to communicate to the CCP running on the IP address(Hos...

what is the OID for temperature value of ISR1101? I have checked MIB CISCO-ENTITY-SENSOR, but my ISR1101 router doesn't have such OID number.

Hey there! I'm just starting in IT, and looking for a little help with the Packet Tracer 2.1.1.5 exercise, the PC fails to obtain an IP from the DHCP and it uses an APIPA instead. Any help?

When I enter the command:snmp-server view ISO iso includedWhat MIB is "iso"? For example, I believe "internet" is: 1.3.6.1I'm not sure about "iso" though.

Hi,I have an issue with configuring TACACs authorization through Cisco ISE for some HPE B-Series switches, model is SN65000B (equivalent to Brocade 6520), Brocade FOS is v8.0.2c. We have followed the instructions in the Brocade Admin guide and can lo...

CAN'T PUSH CONFIG FROM VMANAGE, PNP ISN'T RUNNING, GETTING ERROR: PNP-EXEC-NO-OP

Hi,1- I need to create ssh user who can only see/read the config details of router/switch.2- Also i do not want to share enable password with read-only user, is there any way to create separate enable password for that user too.Thanks & Regards:

Hi , I face this issue 2 times. Installation happen successfully for WAE 7.3.0 using installation process available on CISCO website. But after installation while i am trying to do login WAE cli , credential are not working. i cant able to login usin...

Hello everybody, following situation: We have repeatedly used the Cisco C891F-K9 router among our customers. These devices are rented by our customers. Now, if a router is EoL type, then we'll swap it for a current model. But now it is the above ro...