Metro

We have 7 new metro Ethernet circuits from our service provider to remote locations with qinq trunks. All of these connections are point to point connections terminating at central site using a 7 different s-vlans on a single ENNI port.We need the ab...

Hi,we recieve a number of downstream hand-offs that are delivered as SVID/CVID ccts.  There are mixture of data, and VOIP subscribers, the only way to tell the different type of subscribers is that the all voip services are marked as cos 4.  All data...

We recently changed our T1 services through AT&T over to the Comcast Metro Ethernet Network.  I have 11 locations and each location spoke to each other through a VPN I built using the Cisco RV0xx routers (All Layer 3).  Through the Comcast MEN I was ...

Hi!Is there a show command or another way to read the temperature on a ME 2600X?There is no "show env" or similar.brThomas

Can I rate limit the speed at the fastethernet port itself of a ME 3400 switch?  if not is there any solution or other way to make it work?

Hello All ,               I was trying to do this simple PBR on an ME3800 switch "15.2(2)S1" .===================================================================R2#sh route-map testroute-map test, permit, sequence 10  Match clauses:    ip address (ac...

Hi!,     I have a project were I need an extended LAN to use VMWare Replication but my service provider gives me just One VLAN on a Point-to-Point link (from site A to site B). From my side I have one 3750 on both sides so I was wondering if I can co...

Hi All,Please see the logs below on Cisco ME-3800X, We are using IOS  "me380x-universalk9-mz.153-2.S.bin" %SFF8472-3-THRESHOLD_VIOLATION: Gi0/8: Rx power low warning; Operating value: -20.3 dBm, Threshold value: -19.0 dBm.is this bug ?anyone encounte...

I have configured a dot1q tunnel with l2protocol-tunnel on the uni port of a test switch (f0/1). This is trunked out g0/1 which also needs the protocol tunnel command to work correctly. I have loads of sites already in situ without l2protocol-tunnel ...

All, Does anyone know the link to the Guide for license installation L-ME3600X-16T1E1 and L-ME3600X-4T1E1?What is the procedure?Thank you! Luciane

I have a metro ethernet ring with 13 ME swithces in production with spaning tree. I want implement REP. What is the best way to configure the REP Ports, in order to have the less amount of network interruptions  ?

Is Cisco REP compatible between catalyst and ME swtiches?           

Hello everyone!We're testing a new technology called REP (Resilient Ethernet Protocol - Cisco Proprietary) and the document about it that I've found is a little bit confusing.We're about to do some tests with one router Cisco 7600 and 8 Cisco ME 3400...

I have a private Ethernet Circuit between my home office and colo and wanted to know the recommended Layer II encrpytion.  I looked into some vendor who provide hardware Layer II encryption, but very expensive solution.  I am looking for a cost effec...