MPLS

Can anybody please help me on this matter:I'm finding a discrepancy between Cisco general EoS policy and the 4215 EoS announcement.As per Cisco general EoS policy:http://www.cisco.com/en/US/products/products_end-of-life_policy.htmlSoftware support wi...

we have loaded the above mentioned ios and it is behaving abnormaly. All the internet customers which are using internet adn serving thru a internet vrf are not able to reach outside the cloud. But if we change the ios to 12.4 15 t1 then every thing ...

Hi.I have the following doubt about Central services:I only use one PE for the following scenario:-I have 2 vpn: client A and Managment.-I need to export the loop of an CPE of A to the vpn Managment with a export-map that matches de IP Loopback and s...

In the attached diagram I have tried to make our apathy simple. I'll try to explain the diagram here and then relate my question in hope that malady becomes clearer :)Consider this, we had one MPLS provider all over our offices and life was simple. S...

Hi,I'm a little confused, hope you can help. I'm playing with MPLS TE these days and here is what I read in the "Traffic Engineering with MPLS book" by Cisco Press:After a downstream router receives a Path message, it does a few things. It checks the...

Hi,We have Inter-Provider VPN setup where two ASs are connected using ASBR-ASBR running EBGP and each AS has multiple PEs and customer VRFs. We recently migrated our AAA VRF from AS1 to AS2, the VRFs residing on the ASBR/PEs in both ASs are able to t...

I need help understandind. Let's say we have to locations that have MAN connection and running EIGRP and iBGP between each other.No will connect those two to MPLS. We will be getting routes from 3rd location. So the traffic that is destined to 3rd lo...

Is there any limitation in hardware or IOS in implementing EIGRP as PE-CE protocol in a MPLS-VPN backbone ? I mean, we have all these models as PE equipment: Cisco 6506, Cisco 7606, Cisco 7609, Cisco 2800, Cisco 7513 and Cisco 7206; and these IOS dis...

Hi allWe are planning a Carrier supporting Carrier environment with a Juniper Core network (Provider side), and Cisco 3750 Metro on the Customer Carrier side. What we are trying to figure out is if the 3750 Metro can support CSC with BGP label exchan...

Hi, I am having problem here. Previously, when the MTU was 1508...The cpu load was <5%. When changed to 1512, the load was increasing 70%. Recently, changed to 1522, the load is >95%. Not sure what's going with the configuration. But I can a lot ques...

Hi every1, this query could be a bit long but kindly read it, its very imp. I have a 3845 router running 12.4 20T, with 64 flash and 512 ram. Its utilization on average is 52% !!. This router is the DMVPN hub for 40 branches, other branches are comin...

Hi all,This question regards a very specific corner of the OSPF PE-CE implementation in Hub & Spole topology on L3 MPLS VPNConcerning the area of ospf on each and every pe-ce connection between the spokes and the hub CE's to the PE's.In this scenario...

Hi GS,Can any one Please share me any basic document for MPLS to start up with a basic configuration and MPLS network diagram...Any help on this Highly appreciated!