I have three routers connected via point to multi point (R1 to R2 and R3). I want to split the bandwith i'm getting from my ISP between R2 and R3. R1 is connected to my ISP. what do i do? Thanks Heres's a use case. I'm getting 2Mbps from my ISP comin...
I've set up the following lab. The "customers", most of the purple devices have no problem with connectivity at layer 2 or 3 except R16 and R19.The problem between S20 and R6/R12, as if I get R12/R6 to switch to their backup xconnect neighbours (Devi...
I have a Problem about using a GE port on Route Switch Processor 720 Model RSP720-3CXL-GE (Active Module) as MPLS uplink from the PE router to P Router and the L2VPN (xconnect point to point) are not working. The whole VCs of l2vpn service on PE are...
Hi all. I have Cisco 7606S-RSP720 with ES20 card and latest 15S. Is it possible to apply service policy on SVI interface to police all traffic on VPLS VFI?I am trying to configure traffic policing on a 7609 with ES20 line card - however it doesn't ap...
I understand that in mpls forwarding we have VPN label and the next hop label in which next hop label will be swapped at each lsr? How based on VPN label P routers can find the next hop ? Does VPN labels known to P router also ? Please confirm the la...
Below are my queries: 1. Can we configure VRF without route distinguisher ? If so whats the necessary of route distinguisher in VRFs? Using Route Distinguisher can i select best path ?2. In MPLS, penultimate hop popping remove label at P router itsel...
I dig to know what means "fast-reroute per-link priority-limit high level 1" command.It is under isis of address family ipv4 unicast.I tried to read Cisco command guide, but really don`t know what its means. Generally I know "fast-reroute per-link" p...
Hi Sir, Please refer my issue as below and attachment for log captured; 1) When primary link down at CE_Branch_1, it will triggered the ISDN to CE_HQ to communicate.2) When the primary is up again at CE_Branch_1, the ISDN will be disconnected.3) At C...
I have a MPLS topology with Route Reflector and two vrf Cust_A and MRTG. The Cust_A vrf is configured on all PE and the MRTG vrf only in PE1. It required redistribute the router MRTG's 192.168.0.0/27 network on the MRTG over Cust_A vrf and in turn re...
Hello i´m looking for support os the following MPLS RFC´s on a ASR 903:- RFC 3031 (Multiprotocol Label Switching Architecture)- RFC 3032 (MPLS Label Stack Encoding)- RFC 5036 (LDP Specification)- RFC 3037 (LDP Applicability)- RFC 3443 (Time To Live ...
Hello Techs,Today I ran into some abnormal issue while using select VRF feature. I have pointed a static route with 2 different VRF's & redistributed the static routes in BGP Address-Family, when I leak the route from different VRF (import & export ...
Hello all, I know, this question was asked a couple of times here, I read all the answers, however, I was unable to find the answer that satisfies me. Neither 3 books I read about MPLS TE helped to clarify this part, however, always complementing eac...
