Network Access Control

Dear all, I come to know that cisco ISE posturing is not supported in cisco catalyst switches with LAN Lite image. Is there any way out to manage it with any agents installed ? Regards,Bikash

Hi All,My ACS is performing EAP-TLS for users, but when I enable CRL download checkingauthentication fails, I've tried converting the crl file to pem format but that doesn't work.Yet I can download and read CRL from my browser, Help appreciated.

Hello everybody, I've ran into strange issue - PEAP-GTC is enabled on my ACS 5.6 box (under "allowed protocols" obviously), but the moment an Android phone is trying to authenticate using it, the phone got rejected and ACS log says: "Extracted EAP-Re...

Hi, It's possible to integrate my Wireless Network ( Ruckus ) with Cisco ISE , using RADIUS to authenticate and posture (checking paths, antivírus, etc ) ?Best Regards, Jean Tomáz.

Hi,Does any one had a problem while using SFTP option in ACS5.3.I am trying ot use host-key sync command but giveing below error.I am now frustated with this.ACS/admin(config-Repository)# host-key sync% Error: First character must be a letter% Error:...

Hi Experts, Good Day! I just want to have some clarifications if what I did in my installation it correct.Basically, my I connected 3 cables in my SNS3415 for my ISE and below is the arrangement of the cables1 cable is connected to the port dedicated...

Greetings, I am in the process of migrating to ACS 5.2 from 4.2 and have created custom NDG's for Division (multi-divisional company), however when I go to show Network Devices and AAA clients it shows Name, IP/Mask, NDG:Location, NDG:Device Type and...

I am looking to upgrade from ISE version 1.2 to version 1. 3 and am reading through the upgrade guide. The basic steps they outline are to create a repository pointing to disk: and then run the application upgrade prepare using the new repository. Th...

I have a customer with ISE just updated to 1.3.0 version. Reading the Network Component Compatibilty notes we found some kind of compatibility with Brocade switches is indicated, basically AAA (802.1X, MAB, VLAN assignment, dACL), and some limited pr...

I have a portal to be able to add devices (printers, scanners, VoIP phones. etc.) But it all gets added into a main folder 'registered devices'. I have created subfolders (printers, VoIP phones) to categorize the devices so that they fall in the spec...

This may be a stupid question, but can one register a secondary ACS running version 5.6 to a primary currently running 5.3 without issue?

Hi All,I have SSH setup on a 3850.If i create a user like so:username test priv 15 password testIt will let me login as that user but they will have a password 7 "reversable" password. I dont want this. If i useusername test priv 15 secret testIt cre...

We are running cisco ISE 1.2, we have new AD domain with forest trust relation between both the new and the old. authentication to with the new domain fails.Is there any requirements or configurations change needs to be done to make it success?