Network Access Control

Hi everybody,I have this problem.We have an access router CISCO 3640,IOS c3640-is56i-mz.121-6 for dial-up access andCSACS access-server V 2.4.Users are using a token card authentication (Crypto Card).It works quite good.Encryption is not used.Now we ...

Hi folks,I was running ACS2.6 & using TACACS+ to authenticate dial in users & access to routers. When dial up users tried to telnet to a router they received an authorisation failure (EXEC box not ticked) if they tried to log in. Since upgrading to A...

is it possible for the pix to monitor the citrix ica port for connections and then request a login to the authentication server before allowing the connection, as it does with say a vpn connection?thanks Daren

Hi All, CAn anyone tell me wht configuration i hv to do to run cisco Secure ACS 3.0 server. please give me suggestion or give me any good link. i hv 6509,7513,12208 devices in my network.Thanks & Regards,Ciscobuddy

Hi. I have just upgraded my 1200AP to IOS Version 12.2(11)JA1. I am using LEAP with MAC address auth in the ACS (version 3.0). I cannot get onto LAN though. Error on ACS failed auth report says 'User Access Filtered' even though the MAC of the ca...

Which command i need to enable in a CATOS 6.1(1b)to log in to the Switch by console without authentication in the case that the Switch cannot reach the Tacacs+ Server ?

Hello!I have an ethernet switched LAN with a Cisco 2600 router as a gateway to Internet. In the nearest future we would like to use some billing system based on a RADIUS or TACACS server.Is it possible to "transparently" authenticate LAN users using ...

Can my user profiles data be moved between Secure ACS for Windows?

I had a session timeout of my GUI while configuring the concentrator to use AAA for management but before setting up my admin user with privilege level 15(it is currently set to none). Now I am unable to login to the concentrator.Console login with c...

I am trying to create a user account named:boothjfACS will NOT do it. I can create booth, boothj, boothf, but NOT boothjf. There is not a user with that name.I type in the name boothjf and click Add. It takes me to the screen to define group, passwor...

I have a 3662 with an 8AM card istalled and AAA configured for remote user to dial in,i have configured a single line which will allow dial in, but i dont need any authentication on this line, but when i dial it prompts for a username and password.pl...

Quick one. Does any one here know if ACS for Unix ver 2.3(5) run on solaris 9 ?

I am trying to setup a Cisco 2610 running IOS 12.3(1) for remote access VPNs from Cisco VPN Client 4.02(d) running on Windows.I use certificate authentication (rsa-sig) without XAUTH. Both the router and clients get certificates from a Microsoft Wind...

Hi, in all cisco documentation I looked that the command "radiusradius-server key" is used to authenticate and encrypt all data transmited between router and Radius server but I didn´t find what protocol is used to provide encrypt of this data. I ask...