Network Access Control

Hi,I've a VPN Site-to-Site between two branch offices.What I want to know is, seen that is Site-to-Site, if it's possible, with a PIX, to add User Authentication before the traffic is sent to the destination network.If Yes, as I suppose will be based...

hi...does anyone know if 802.1x is a protocol (or frame interpretation rather) that is supported on win2000 for any nic?is there a minimum OS and NIC requirement to able to dynamically assign VLANs based on user by using 802.1x?regards,c.

Hello...I'm trying to configure IAS Radius server to login users into a CISCO 3640 router. The idea is that different users login with different privileges... Some users with privilege 15. I've been checking the logs of the IAS server and it's workin...

How I can monitor in real time the users logged using the ACS server ? Is it possible to develop a HTML page with autorefresh ? if yes how ? If not which tool I can use to do the monitoring ?

If a user ID is disabled on CS ACS and the user tries to login after his account is locked out, he does not get any message. He is prompted again to enter his ID. Is there a message file where messages can be controlled for different kind of failed a...

Hi,I am planning to use TACACS+ for managing routers and switches. I need to know if TACACS encrypt telnet session ? Right now we are using SSH for encrypting telnet session. Thanks in advancealtaf

I have two ACS v3.1, and one of them have been stopped by the system.The CSMonLog says: "Service CSAuth has been stopped or paused by the system. Monitoring will suspend until the service is restarted.".Does anyone know what could be happening?I have...

Hello ,we want authorize Dialin User AS5300 against a Steel-Belted Radius . The Radius accept the request , but the Cisco AS 5300 reject with the following Message:6w4d: RADIUS: Received from id 241 10.9.10.10:1645, Access-Accept, len 606w4d: Attribu...

Is anyone aware of a method of either bypassing or authenticating a non-user device such as a printer with the User Authentication requirement on a hardware client? I would like to use this feature, but have equipment requirements which can not provi...

Hi please help.The set up I have at the moment is VPN 3030, ACS 3.1 server, and CA server.I can not get the VPN client to authenticate the user against the ACS server which is mapped to the domain controller.On the 3030 VPN concentrator I have create...

Hiya,I am having problems getting a large amount of our Cisco routers to talk to our two TACACS+ Cisco Secure 2.6 servers, I am pretty sure its not a router configruartion problem as the same configuration works fine on some routers but not others (s...

I hope some one can help me... I am trying to configure a router with 12.13.t4 (2612) to use aaa to authenticate web server users with a Windows 2000 radius server. i have done this for local logons to the router and this works ok. But I cant seem to...

I need some help in configuring multiple IP addresses for one user in ACS 3.2 Win (Radius). I want to setup a user so that he gets different IP address depending on which NAS he logs into. Can anyone point me in the right direction?NAS1: VPN3030NAS2:...

hi all:installing acs 2.3.(6) on solaris 9 was easy and straight forward and it starts successfully with no problems:................................................Starting CiscoSecure Processes: Fast Track Admin Started FastTrack Server (Delayed St...