Network Management

Hello,I have added 3 new devices in CS and then create a group in RME then add the 3 devices in this group. Then I have run the credential check added devices in inventory and backup the configuration successfully.Problem:These devices are not appear...

How can I copy the complete router configurations from one router to another? Please explain on the basis of the following scenarios:1. Both routers are of the same model.2. Both are of different models (one may be Cisco, the other, Juniper).

I am getting the following error:OutOfRange::Component=VOLT-xx.xx.xx.xx/7 [ASIC voltage in mV];ComponentClass=VoltageSensor;ComponentEventCode=1080;ciscoEnvMonVoltageThresholdHigh=1050;Status=OK;RelativeVoltageThreshold=0.0  %;CurrentValue=1.052;cisc...

Hi,I installed a new 3925 yesterday to try and replace and older 3825, hence i was burdened with the task of first adapting the config to work with the 3925 which had a different hardware spec, and then copying IPT files off the CF which became a nig...

These three topics together? So far, no way!Does anyone have a solution how to manage ASAs 8.2 with ciscoworks lms 3.2 via snmpv3?I am almost depressed that this is not working, although I implemented the newest patches I found.Inventory job: "device...

Hi GuysWe have LMS 2.6 installed on a dell server. We are buying some new HP servers for LMS 4.0.My question is this:1) Can we install 2.6 on the old license on the HP server and upgrade to LMS 4.0 using a upgrade license? (The dell server will be de...

What is the meaning of "flushes" in below output from "sh log" command?Syslog logging: enabled (0 messages dropped, 704 messages rate-limited, 2951 flushes, 0 overruns)Thanks for help.

Hi All,I have 20 PIX and ASA firewall have been configured in my ciscoworks (lms 2.6)I am able to get alerts like device down and authentication failure messages through mail, I guess these are from DFM.My present concerns....Configure syslogs in fir...