Network Management

Hello.....I have a problem that says "error in communicating with IPMprocess or ipmDBengine" in Ciscoworks ...could anyone help me ?Thanks,Hisham Karem

Hi, I'm trying to retrieve historical statistics from a 7206VXR Version 12.4(15)T11 via LMS3.0.1 CiscoVIew mini-rmon Version & Patch Level: 6.1.7    Port Name Buckets Requested Buckets Granted Sampling Interval(sec)       Owner      1.Gi0/250501...

Hi,I'm upgrading 3.0.1 to 3.2 version. In the process of upgrade, the setup program asked me for license file. I was thinking it will automatically found old one. I found several license files in my system:Under \CSCOpx\etc\licenses there are 5 .lic ...

We just order LMS 3.2 installation DVD from Cisco. So we will upgrade it from 3.0. Based on the Cisco document, before I upgrade it, I need to stop service and backup data. All of data will be automatically migrated to new version with local installa...

I was curious about what kind (and how much) network traffic LMS3.2 generates on a continuous basis, and found that it continually sends out multicasts to 239.255.2.3.  In trying to dig up information regarding that multicast, it appears to have some...

Hello all,I have installed ciscoworks lms 3.2 on windows 2003. The discovery ran successfully and the devices were added to dcr.After a few days, the ciscoworks processes were automatically down.“Processes NOSServer, CmfDbMonitor, FHServer, IPMProces...

Hi All,1. While trying to generate Device Manageability Status Report, I noticed that the Config Status of all devices is Failed. The reason for the failure on all the device is as follows:Failed to establish TELNET connection to 10.180.9.172 -Cause:...

Hi,I have been doing some reading about EEM, and I would like to know if its possible put the tcl scripts on a TFTP server instead of putting them on the router's flash?This is the code I used when the tcl script was on the flash:--------------------...

Hello Cisco Support CommunityI hope anyone can help us.We have got three WS-C4510R in our company with equal Supervisories and we updated the IOS versions on Saturday, so that all IOS-versions are the same. But now, one of the three has a new OID num...

I have a Catalyst 4003 with a locauser configured and local authentication enabled as backup.  Tacacs is primary auth method.  If I perform a "Device Credential Verification" for "Telner Enable Mode Username and Password" with the Tacacs server reach...