Network Management

Hello, i would like to know if it is possible to make changes in the configuration of the cisco equipment with CiscoWorks LMS 2.6 if i have only configured read/write community.(no telnet password configured)Thank you.Eduardo

I am looking for a good network monitor tool that is freeware we have a good size network over 7 states.

If I stack multiple switches, is it consider to be two devices or just once device? Is the configuration file seperate or consolidated as one file?

Hi, Does anybody know of a good product to use to compare device configurations to a reference which will give a nice report showing the differences in each switch? The idea is that we want to standardise our configurations as much as possible. So...

Hi,I have several switches 2950 and sometimes they give this message error:Cat2950Family 10.0.0.1 SNMP SVCDOWN at 12:04:11Status: Active and responding ( 0)and after this it gives:Cat2950Family 10.0.0.1 SVCUP at 12:04:35Status: Active and responding...

is there a simple way i can configure the router to send me its dialer (dsl only) ip address everytime it changes? i am remotely managing the router and it's only connected through 4 DSLs dynamic IPs, no name is set for the router.

Hi,I am trying to remove a snmp trap host from the "show snmp" output. It is not there in the running configuration. But it shows in the "show snmp" output. Is it a bug? IOS is 12.2(18)SXF5. Platform is 7600.DOH-7600#sh snmp Chassis: FOX083306Y...

What am I doing wrong. I am unable to capture text on Hyper Terminal and save it to notepad. First I highlight the text. then go to menu >transfer>capture text>filename.txt. When I go to open the file it would be blank. Is there any precise way to do...

I'm looking for Cisco's NBAR software for router bandwidth shaping. I can get all the way through the documentation and where to download, but I then get told that the software is not available. Does anybody still have a copy of this kicking around o...

I have many Cat1900 Series switches automaticly discovered. However I am unable to retrieve configs from these devices. Here is the message when I look at Archive Management\Failed Devices. Currently I have Config fetch method with telnet and tftp...

If switch "A" is replaced by switch "B", how do I remove switch "A" from the topology map without deleting/removing it from inventory?

hi: i'm new with the LMS technology, so i have a question about de LMS HW requirements, i saw this especification:Requirement Type Minimum RequirementsSystem hardware? IBM PC-compatible system with 1 GHz or faster Pentium processor.? Color monitor.? ...

G'Day,I have upgraded from LMS 2.2 to 2.6. My problem seems to be that the restorebackup script doesn't seem to be completely working as DRCServer cannot be started. I installed the backup patch (1327) prior to the upgrade. The migration.log file ...