Network Management

Is there a way to make a custom report that shows just the uptime of a given device?

What can i check when i cant have senders adress in emails which have come from RME. E.g. when i get alarm generated by automated action.(when err disable error occurs i got alarm in email but there is no senders adress.)

I have the following problems.Archive ManagementThere are a lot of devices that are not updated. The msg is the following.Telnet acces is not correct, i am sure that the value is correct.Campus ManagerMy campus manager is in running status from the 0...

hello,Runing the global discovery every 4h and a major aquisation every 2h : is that don't make a lot of traffic on the network (network of a telecom provider) if yes what the best timing to do the global discovery and the major aquisation.thanks for...

Hi, Is it possible to raise an SNMP trap for spurious traceback errors etc., Thanks Mary

I have a question to ask regarding Cisco ACS version 3.3 .We are about to install the software on a Windows 2003 Server platform with the following spec:Dual Pentium 3 - 500Mhz Xeon Processor with 1.5 GB RAMThe installation notes specify a minimum sp...

I'm using LMS 2.5 (Ciscoview 6.1). I can't find how to see the POE configuration of the ports with CiscoView on Catalysts 6000. Is it possible?

Hello,We have a small LAN with 200 users , but with 30 WAN links (Leased lines + ISDN lines)for remote connectivity. Can we have some NMS to monitor the LAN + WAN links . I would appreciate if there is any free NMS available?Thanks

hello,i have some problem to configure my PIX 501 (firewall & VPN).my problem is on the outside interface. the link is down and the interface is shutdown.i think that this both thing are link but i don't fine a way to put at up the link.more over the...

Any idea how to enable Syslog on Ciscoworks2000, LMS 2.5 Version?thanks

Please i would like to know what have I to know (SNMP, VLANs ...) to can manage a network with CiscoWorks LMS 2.2.

In this senario I have a 3550, (2) 2950's and (2) 2924's. I have the code upgraded to one of the latest on all of them and the only switches I see besides the 3550, are the 2924's! Where are the 2 2950-12's!?

Hello,i work with LMS2.5 on Solaris. I use CampusManager 4.0.2 for the Discovery and automatically add the discovered devices to the RME 4.0.2. Unfortunatly i must add for every new device the telnet and enable user and passwort by hand. Is there any...

Does Ciscoworks support microsoft windows 2003 clustering or any clustering solution?