I have recently been tasked with updating the description section of my cisco switch interfaces with the patch panel number that each interface is connected to, does anyone know of a way to do this by uploading a giant csv file? Or do I have to hand-...
Hello!Sec team scaned ip ranges and reported that a number of branch Cat9500 core switches respond to network and broadcast addresses:CORE1#sh run all | b interface Vlan 21interface Vlan21mvrp timer leave-all 1000mvrp timer leave 60mvrp timer join 20...
I need help resetting our GUI admin password. I've done my research and couldn't find anything useful. I've checked the documentation and looked through discussions here and not having any luck. Our network is isolated, so we don't have email associa...
What setting is 'EAP-TLS L-BIT' in ISE 802.1x authentication did not work, so I checked and found that this item was checked in the allowed protocol. Unchecked, 802.1x authentication was successful.
As the title says, has anyone done this successfully in regards static routes, EIGRP to BGP switch over . I am not sure that Velo could replace this but , the bosses are sold on the buying do to SD-WAN on the platform. Any info will help.
Hi all, Like many I am trying to stop the DOS attacks using ntp mode 6 control. We do have ACLs configured to guard against this attack however, the vulnerability scanner that our organization uses still shows it as an open. I know there is the co...
I cannot seem to get SNMP working correctly on my Cisco ASA 5525. I'm trying to add this ASA to PRTG for monitoring. When I attempt to add any SNMP sensor in PRTG I get "No response (check: firewalls, routing, snmp settings of device, IPs, SNMP versi...
I have an issue where there are 2 site in Japan do no connect to TACACS. We're running TACACS on the ISE deployment. We're pointing the two isr4k's to the PSN nodes at the HQ. We do a packet capture, at HQ headend device, and see the back and forth ...
I can’t figure out how to confirm a command on the ASDM CLI. I’m baffled there isn’t anything online to say here’s how u say yes, execute, hit it, engage, etc. Not even the Cisco software help specifies how to say YES in the ASDM command line. Please...
I have Juniper ex-2300 connecting to Cisco Nexus 5k by fiber. The problem is Juniper will show the link lights but cannot bring up the Cisco Switch showing the link down. They have matching SFPs. I have verified that I can bring up the Cisco switch w...
HelloSo I have DSL 40/5 Service and for the past 2 years I have had no issues. As of this past 3 weeks I have these insane lag spikes. It could stay normal for 30 minutes or 5 hours, then it happens. My 30ms goes to 2000-3000 ms. It either will not g...
Good day, to whoever is reading this. Also, if I submitted this subject on the incorrect location please let me knowI'm currently a network specialist for educational institution and it is expanding very fast. I'm pretty sure that one of these days I...
When specifying a file path for our config archive, the standby and member switches reboot. While the active switch stays up, the other switches in the stack reboot as soon as the command is entered. If the command is not removed before the switches...
Hi Everybody i have been experiencing an issue on my local network lately every time it keeps disconnecting from the internet i'm using a Cisco rv110w router and the ISP is Cisco. I've tried to disable the firewall and other stuff it keeps going bad ...
