Network Management

Please I need any help or advice I can get. My switch was working fine all of a sudden the computers connected to the switch stop receiving connections. Upon checking the switch, I discovered all the lights on the switchports are off. So I disconnect...

Does sh env power only show power for a line card and not the whole chassis? 

Hi members,I have a laptop with the following hardware specifications: i5 1035g1 ( 4 cores 8 threads ) 16 Gb ram I want to run cml on the laptop with personal licence ( under 20 nodes ) and I have a couple of questions. Your advice is appreciatedThe ...

AP9115 is joined on WLC3504. I don't know what the default value isRogue detection was checked. Will this setup affect the wireless? After tasks such as poe replacement or ap reboot, the terminals are connected wirelessly, but there is a phenomenon i...

Hello I'm hoping you can help.I have two ports on the Cisco 2960 device: the first is the main port, and the second port is the backup. What I want to achieve is that when the main port goes down, the backup port will go up, and vice versa. I thought...

Im trying to copy the below file, but it dosent copy to USB.copy flash:TAC_memory_monitoring.txt usbflash0

In what circumstances do I check the settings in the attached picture? I would like to know the difference in the service impact of whether or not it is checked differently for each flexconnect group.

CCTV camera not working properly ,,, frequently disconnecting.it's connected with cisco access switch 

Hello team, I have some weird notification on WS-C2960G-8TC-L. Our monitoring system is sending us: Memory on "Main (Processor)" is high! Alert: Memory on "Main (Processor)" is high! - Current: 80 %, Threshold: 80% Status: OK Severity: Major   But wh...

We need manage cabnite/rack/pdu etc, which tools is good? And opensource solution can make it?