Network Management

Yesterday, we upgraded our instance of Cisco Prime Infrastructure to 3.1.6 (from 3.1) and added device pack 12. This morning, we discovered that several of our switches had the following line removed from their configuration by CPI: snmp-server host...

Hello I am trying to make Prime perform a write mem redundancy reload shelf on a VSS switch in order to restart both switches in the VSS The switch asks for a confirmation - <enter> seems to be the only answer that does not abort the operation VSS-...

Hello All, Router: ISR4321 IOS: 15.4(3)S4 IOS-XE: 03.13.04.S I have a GigabitEthernet interface that is configured with "ip address dhcp" to get a dynamic IP Address from the Cable modem/router connected to this interface. And I'm wondering if ther...

Is it possible to configure remote archive/backup of ios devices to an sftp server? I need to archive switch and router configs to a server, but can't use tftp because it's insecure.

Hello colleagues.I have found some snmp trap OIDs from cisco devices, which cannot be found by Cisco SNMP Object Navigator:.1.3.6.1.4.1.9.9.198.0.3.1.3.6.1.4.1.9.9.513.0.19.1.3.6.1.4.1.9.9.513.0.25.1.3.6.1.4.1.9.9.513.1.6.1.0.2.1.3.6.1.4.1.9.9.524.0....

I have Cisco Prime Infrastructure 3.1 in my network and it monitor third party servers such as windows servers, linux ,..but in the monitor page show me Cisco callmanager in device type , so is there method to change the device type? another question...

Hi, i am trying to enable ssh server port 830 for NETCONF. I have the pie k9sec active. But when i commit the command: RP/0/RSP0/CPU0:dc18xr01(config)#ssh server netconf port 830RP/0/RSP0/CPU0:dc18xr01(config)#commitMon Jun 19 15:54:09.977 CEST The ...

Hello!I have set up a database to collect desired information from Cisco prime for a long period of time.One example would be to gather interface statistics on all of our switches and then compare if anything has changed since before.Reason why I wou...

Dear Friend Recently I have installed Cisco Prime Infrastructure 3.0 for one of our customer. I add the devices and now I did configuration archive for some devices to backup the configuration. kindly please tell, cisco prime infrastructure 3.0 by d...

Hello All, Switch: Cisco Catalyst 4510R+E IOS-XE Version 03.06.03.EIOS Version 15.0(1r)SG5 I am adding some more commands to our 4500 for supporting client authentication through Cisco ISE (*RADIUS and AAA). And in the configuration guide found in C...

Hi.. Good morning i have no experience in the LMS  can please any one tell me how to take the backup for Cisco switches or from where can i see it if its already taken Regards

hello  I have Prime infrastructure 3.1.0 and i have been recently getting this error  "Component: Health Monitor, Server: Primary, Type: Process, Service:Prime Infrastructure, When: Startup, State: Stand Alone, Result:Warning, MSG: MATLAB1 servic...

Dears I have two Cisco Prime hardware servers which are working together by automatic failover  primary was active and secondary was standby after by reload the primary server, primary become standby and secondary become active since this i tried man...

Hello, I use Cisco Network Assistant 6.2 to access and see stats, port settings interfaces front panel of WS-C3850-24T model switch. It does not give front panel stats in, it does show for other new and old switches no problem