Hi all
i config router to send netflow packets to Netlfow analyzer , the interface which need to be monitor as below :
but from the netflow anaylzer UI , it received more interface :
i consulted Netflow analyzer team , please check the Link:
htt...
How can I take the following tcl and with EEM schedule it so the router pings the list of IP addresses every 2, 6, 8, or 24 hours?
router# tclshrouter(tcl)#foreach address {10.x.x.20110.x.x.20110.x.x.20210.x.x.20310.x.x.20410.x.x.20510.x.x.20610.x.x...
Hi all,
Does anyone know how a Rule Input with multiple values can be used?
For example I want to check if a specific SNMP trap source interface is configured (snmp-server trap-source Vlan10)
In our network this could be Loopback0 or Vlan10. If I cr...
Hi All,
What would you recommend is the best tool to test the bandwidth and traffic on an MPLS network from one site to the Datacenter, we have an issue with one of our supplier where their application seems to be the problem in transferring data t...
Hi,
I have one cisco 2960 switch, on connecting console cable we are getting below error
"hulc_reset_pcie_asic_phy: Unable to access MDIO backdoor"
please assist.
I find that I'm able to use "package require udp" in both the interactive TCL interpreter and in scripts that I keep in flash. For example:
router#tclsh
router(tcl)#package require udp
1.0
router(tcl)#
Using that same directive in an EEM policy scri...
Hello,
I tried to distribute Software Image on 2960-X with Prime 3.1, but that doesn't work :
Cannot coerce string type to XML document type, the empty string is not a valid XML document.
My Prime version is :
hdv-prime1/admin# show version
Cisc...
Here are the details of the critical error:
Cisco UCS 5108 Chassis: Serial # ............ Sys/chassis-2/locator-led
Description: [FSM:FAILED]: set locator led to inactive (FSM:sam:dme:EquipmentLocatorLedSetLocatorLed).
Remote-Invocation-Error:
Caus...
Is there a way to pull data out of PI 3.2 to have it published on web page that does not require authentication?
Usecase: We have TV's around the office that display different things that are going on. The system simply points to a URL, displays it ...
I'm trying to change the SSID passphase on our Aironet 1242AG APs but the SSID is not displaying on the GUI. If I telnet to the devices and show running config it shows the SSID.
All,
I am trying to figure out why when I add these particular devices on cisco prime 3.1 device information is not updated. the device ip's are added to the datase but they show as unknown device and wont pull all device information as the rest of m...
Does Cisco Network Assistance 6.3 support HTTPS..??in switch side; I have disable http server with : no ip http server andenable https with : ip http secure-server
now the switch does not get connected in CNA after enabling https..
How to make Switch...
Hi,
I'm a little taken aback at how difficult this is and I'm wondering if I'm missing something right under my nose. I set up several IP SLAs to monitor RTT on our WAN links and they work fine ... if you log in and type "show ip sla statistics."
W...
I'm trying to figure out how to change the shell password that gets you to the linux commands in the CLI for Cisco Prime 3.2. I know the current shell password but we want to be able to change it every so often. Any suggestions?
Thanks,
Brett
