Network Management

Hello All, Switch:  WS-C4507R-E Supervisor Slots: NAME: "Supervisor(slot 3)", DESCR: "Supervisor 6L-E 10GE (X2), 1000BaseX (SFP) with 2 10GE X2 ports" PID: WS-X45-SUP6L-E , VID: V04 , SN: ********** NAME: "Supervisor(slot 4)", DESCR: "Superviso...

We have implement's Joe Clarke's TCL scripts to disable unused ports after a specified period of time. I am having an issue while testing. My understanding is that when a port that is listed in the susp_ports.dat file comes active the port is removed...

Hello I would like to know if it is possible when there is electrical problem and the routers restarts many times, example 3 or 4 in a short time, is it possible the router loses the configuration? or it should charge it without problem? I hope you ...

Hi all,I have an issue with a couple of ASR's and retrieving certain SNMP interface statistics.  I can collect values from one sub-interface, but not another.Correct retrieval of statistics (increments as expected)bash-2.05$ snmpwalk -v 2c -c <commun...

Regarding PnP, are there a downloadable package of plug and play templates for the PnP app in APIC-EM.  All of the documentation regarding this app references Prime and that the templates are imbedded in Prime.  I'm not seeing default templates like ...

Hi ! Is there a way to create a report in prime 3.1 that exports all devices with the information about one device in one line, comma separated? With the information like this? Ipadress, device name, produckt id, seria lnumber, software version, mod...

Dear all After installation PI_3_1_5-1.0.44.ubf - PI 3.1.5 Maintenance Release. to Cisco Prime Infrastructure 3.1 Virtual Appliance image i have Major alarm on my Cisco Prime infrastructure and some modules are not working.I was tried restart this ma...

Is there a way to removed interfaces from being monitored?  I keep getting alerts for interfaces that will never be "UP", but I don't where to remove them from that alert setting.

Hello i am receiving the following error while adding a Cisco  ipv6 device in prtg server Sensor does not get response from device. SNMP credentials are wrong or device does not support the required uptime OID (1.3.6.1.2.1.1.3.0) for traffic sensors....

Hey guys, I have a silly question: I have some catalyst 2960 and 3850 switches. I would like to monitor them with snmp. But where do I get the OIDs? Or how can I find them out? For example for monitoring the fan status, power supply status, temperatu...

Hello, I would like to know if pfr mib is supported in IWAN environment to get the path details. Regards, Sri