Network Management

Hi , I am facing one issue where Netflow is not working on 3560 after the IOS upgrade to 15.0(2)SE8. All the configureation is fine .Let me know if you have any solution for the same  Regards ANU M

Hi , Can anyone point me towards the correct MIBs/OIDs for identifying the card type, slot and serial number for the interface cards installed in 29xx and 1941 series routers running 15.1(4)M7 IOS versions? I see there is a deprecated cardType OID .1...

Hi All,        My PI versio now is 1.3.0.20 with patch PI_1_3_0_20-Update.4-16.gz as attached, however when tried to upgrade PI 2.0, we got the error " manifest file not found in the bundle after uploading the patch "PI-Upgrade-2.0.0.0.294-2.tar.gz"...

I have EEM applets running on a large number of routers in my environment and it works fine everywhere..However I have a handful of routers where it's failing to execute and I have figured out whats causing it but dont understand why the router wont ...

Occasionally we get the message that logging can’t keep up but within seconds to a minute we get a second message stating it has “caught up”. The Critical message is:Reporting Client: The reporting system is unable to maintain the rate of data being ...

I tried to add Wireless Controller  5525 to Prime Infra 2.2. In the "Network Devices menu" and device type show "Unsupported Cisco Device". and It did'n have this probem with WLC2504.

Hi, Could some one please provide asisstance as to what I am doing wrong in setting up the static routing, In the Destination LAN IP:  192.168.2.17 (Other network IP Address)            Subnet Mask:           255.255.255.0            Gateway:       ...

I have an EEM script that generates this output based on monitoring my WAN interface load: %HA_EM-6-LOG: INTERFACE_LOAD: BW: 50000 kbps/sec || TX: 15/255, 1651000 bits/sec, 598 packets/sec || RX: 8/255, 3057000 bits/sec, 627 packets/sec I would lik...

Hello, I´m with TCL and EEM on a ASR9K a newbie. I have a script running already on IOS. event manager applet forbidden-commands-bgp trap event cli pattern "(.*)(no router)(.*)" sync no skip yes occurs 1 action 2.1 syslog msg "$_cli_msg not executed"...

Hi everybody, my customer wants implement a NAC solution with Forescout counteract. This solution use snmp write community for vlan remediation,shutdown ports...ecc. I would limit snmp write (with use snmp-view) to only vlan/interfeces commands. Is i...