Network Management

Hi All,1. We have installed LMS 4.2.  And the upgrade path we chosedLMS 4.2 -> LMS 4.2.2 -> LMS 4.2.4 But post installation we have found  from the software update page was showing the version has 4.2.2 even upgrading the  version 4.2.4.2. due to abo...

Hi there,we added LAN switches (L2/L3) to the PI2.0. There are some strange things:Thing 1 Alarms - configured the switch like this:Global config:logging buffered 16384logging host xxx.xxx.xxx.xxxInterface config:Port 1- 24 Access Portsno logging eve...

Greetings,I have a EEM script that looks for OSPF down/full neighbors, but I am wondering if there is a way that I can have the EEM Script look for the current date that the script was run?For example, if I have an OSPF neighbor go down, is there a w...

Hi,Can some one please advise.I am have an issue with LMS where it is not fully comming up. I have shut down and restarted several times, with the latest giving me the following result within the macuhic.log, attached also PDSHOW :Informational: Star...

Hello everybody,       we are using NAM traffic analyzer 4.0 in our network . i want to capture packets flowing in and out of a particular interface of switch. Is it possible ? 

Hi,I have installed CPI 2.0 and I have almost 100 switches and routers registered.I would like to monitor a few interfaces (trunk interfaces, not access ports) and i would like to send an email notification when this few interfaces goes up/down. Is i...

Hi I install LMS 4.2 in one of my customer place.First I install LMS 4.2 then 4.2.2 there was no issue after that while installing 4.2.4 its given error as follows.>SetupNew\setup.cpp (143)PAPP;PVENDOR;PGUID;$@Windows Vista Service Pack 1 (7601)IE Ve...

Hello , I am trying to upgrade from Cisco Prime (virtual machine Vmware) version: 1.3.0.20 Patch : Cisco Prime Network Control System Version: Update - 1_12_for_version_1_3_0to 2.0 using the following command:application upgrade PI-Upgrade-2.0.0.0.29...

Does Smartport support the 1142 AP and the 3502 AP?  It keeps comming up as a Router device - CISCO_ROUTER_EVENTThe 1131 AP work fine.

Using this script, when I execute it, it stops at Erasing VLAN Database and sits there until I hit enter again, then it finishes the script and reloads the device. Thoughts on why?tclshputs [open "flash:reset.tcl" w+] {puts "Erasing Configuration"typ...

Hi Guys:I want to access lms database,my lms version information as attachmentbut i can't find db/win32 folder,this is because my lms version is x64 or other reason??

Hi,We have recently been trying to resolve a few issues with routers which get partial inventory failures upon discovery. I have managed to narrow this down slightly with the help of the inventory.log file. (With help from this post https://supportfo...