Network Security

Hi guys, I am running an ASA 5505, V8.2.5 with security plus license. I have added an additional vlan (Vlan100) to the asa and need it be identical in nature to vlan 1. For someone reason for PC's that are connected to vlan 1, I can't ping the gate...

Hello We have purchased a new cisco firepower 7010 series I have assigned managamnet ip address and can access using the browser. My problem is that the browser is not showing all features except few best regards

Is there any way to use the ASA 1000V cloud firewall without having to register it with the Cisco Virtual Network Management Center [VNMC]?

I need to setup Role-based access for Helpdesk and Desktop Support guys. I know i can do this with 'views' but i need to have a log of who made changes and the changes that were made. If possible i would like to only give access to local resources as...

Just clarifying the description of this vulnerability. if hosta is flagged as the source of searching via SMB to hostb for phoneinfo.dll, is the vulnerability in 37558 talking about a vulnerability that might have occured on hosta that caused the res...

We recently deployed an ASAv in AWS and just applied the smart licensing.  While the licensing was successful, we are showing Out of compliance.  I'm trying to figure out exactly why we are out of compliance, but I don't see anything that gives me th...

I have a "public" network that we use to test our websites and other stuff from an "outside" network. This is just a cable modem attached to a 5506 and then a switch. From this network we regularly test our enterprise network and firewall. The proble...

I need to NAT or PAT, a couple inside hosts to the outside interface. Problem is I don't want to create a NAT pool for the couple inside hosts to NAT to.

I'm looking to configure a pair of ASAs running two contexts in an active/active failover scenario. Is there a "best practise" in the order of configuration sections for doing this? Would I be correct is assuming the following - first of all create...

Got a new install of two 7125 appliances and VM  Management Center. All three are on 6.0.1.1 code. Both Appliances show as unlicensed, and I have two FP7125-TA-LIC= licenses, but no means to apply them (no PAK).  I can't seem to find any information ...