Network Security

Does anyone knows if PIX Blade will discontinue or be replaced by a new one (similar to IPSEC SPA). We are in the process of investigating for a new project and the hardware is quite old. Most vendors are invastigating in multicore processors.

where can i find this:60-day trial license that supports signature updates that require licensingfor ASA-SSM-20???Thank for all

Hello,We currently have an ASA 5510 at one of our sites with about 3 other site-to-site VPN's connected to it for all our branch offices. I setup the Clientless SSL VPN(WebVPN) and I can access everything on the local network that the ASA is attached...

Dear Sir,I have ASA 5510 with aip-ssm 10.My issue is how to have access to the module from the lan and allow it to connect to internet. i have created a static translation: static (inside,csc) tcp 10.10.10.5 https 172.16.100.5 2000 netmask 255.255.25...

Hello,Are these config ok, as per need.But till not working except SMTPRequirement * allow SMTP traffic from outside to host 80.1.2.3* allow port 5512 from inside to outside for host 192.168.20.50* allow inside host 192.168.1.10 to communiate on port...

Is there a way to allow access to Clientless (webvpn) for some users but not to AnyConnect? We want powerusers to use AnyConnect and normal users to use the Clientless. Right now all users can access either one. We're using IAS RADIUS for authenticat...

hello partners and experts,We use the RVL 200 to establish VPN connections. Now we have one PC with windows 7, and there is the problem that there are error-messages when installing the xtunnel. we did it as an administrator.We use the virtual passa...

Hello everyone, I'm having an issue configuring a phone proxy.  When I enter the command: (config)# ctl-file ctl_phoneproxy_file(config-ctl-file)# record-entry cucm-tftp trustpoint phoneproxy_pub_trustpoint address <ip_address>(config-ctl-file)# reco...

We purchased a used Cisco 3005 with IOS 4.7 on it. We are wanting to use the WebVPN for remote sales people to access items on our network.We are trying to get the AD authenication to pass thru to those website from the main site we have setup for t...

Hello, hopefully someone can help me out with this. I'm CCNA level, but not very familiar with Site-to-Site VPN setup. I have an ASA5510 for a remote site and trying to connect to a 5520 at the main site. I am not seeing the tunnel come up at all....

i m little confuse need your help.Stateful firewall in which state create whn packet comes from lower interface to higher interface it first check stateful if connection there packet allow if not pakect deny stateless no connection table create the...

This is a general query & doesnt the error seen is not of a cisco firewall. this is from a mcafee firewall which quite often gives "all nat ports being used" message.Not certain what it means & if it has impact on overall performance of the firewall....