Network Security

Is PIX able to do intervlan routing/subinterface?i have a small setup..in order to save cost i would like to eliminate the use of a router and have a PIX insteadInternet|PIX|Layer2 Switch(with 3 vlans)My objective is to do restrictions such as below....

Dear All,I just bought a Cisco PIX 506e firewall.Here is my current network configurationISP - VSAT RCST - ISA - SWITCHNow I want to add PIX as addl security and for VPN later, so my setup will become like this ISP -- RCST -- PIX -- ISA -- SWITCHBefo...

I just tried to apply the 5.1(3) Service Pack and after wondering why the upgrade command was not available determined that my admin account no longer has administrator prevlidges. Anyone have an idea how to get this set back? The admin account is th...

Error Message:Error converting config. Install aborted. Any help? Thanks in advance

i have two internet connections with one PIX for each connection i want to make configuration to make the backup between the two connections

Could anyone help me reseting all sigs to solve the problem with the upgrading from 4.1(5) IDS to 5.0??

Hi, we are having some voice quality issues with with our home users who are running CISCO VOIP from home. we have a simple setup:[7960phone]-[pix501]-[cablemodem]Pix 501. 6.2ver does the VPN to our corporate network.can i prioritize the VOIP traffi...

Hi, Can you look at what I believe to be a false positive for sig 5551Thanks,evIdsAlert: eventId=1116783457905897506 severity=high vendor=Cisco originator: hostId: Vintage01 appName: sensorApp appInstanceId: 340 time: 2005/11/01 01:06:33 2...

This signature triggers on =shell: anywhere in the tcp stream.Isn't there a way to tighten this up? If fires even when I got to the Cisco MySDN page for this signature (because it has the word =shell: in the html returned).

Hi. I set up an ASA 5520, and while consoled into it all seems well. I did some basic tests, can get out to the internet and all is well. I plug a client into it, and it gets its dhcp address just fine, including dns, gateway etc. however the client ...

I have configured my PIX-525 running version 6.3 to send the system messages to it's internal buffer.However the messages are not time-stamped.I have also enabled the logging timestamp command.I read that the logging timestamp command only "timestamp...

Is possible Upgrading from 4.1 IPS to 5.0 over ssh? or must it be over console?

I noticed the hard coded speed and duplex settings for interface Management 0/0 do not replicate from the primary to the standby ASA. Do I have to manually hard code these on the secondary? Will the settings keep after the unit restart since it get...