Network Security

Hi, using ids 4.1, can somebody tells me how to disable a signature for some IP destination only?Thanks.

Ciscoworks-VMS-Large enterprise-Remote 4235 sensors running 4.1. Is there any way to easily allow remote locations to VIEW alarms on their individual sensors? If not, is this feature in the future?

Given is a PIX 515E with three interfaces. I've configured three VLANs on the 'inside'-interface. As far as of PIX OS 6.3 it was possible to account the traffic for each of the three VLAN interfaces independently with mrtg. Since PIX OS 7.0 the stati...

I had Cisco configure this device. I needed to go in and open up a few more ports and map them to a new internal IP. This is the first time I have been in the unit since Cisco configured it. When I log in I can only access HOME and MONITORING modes. ...

I am looking for a IDS/IPS which should have minimum of the following,5 ethernet 10/100 built in ports,2 GB built in ports for monitoring,2 response port,1 management port,should support Virtual IDS by VLANs and CIDR,Should support the following mode...

Folks, I just installed IPS 5.0 on a sensor 4210, i am reading the manual and i also got a trial license. But, i am still confussed, where do i see the events if some attacks my network, do i still use the event viewer? i know i should use VMS, but i...

Please advise if MSN messenger 7.0 is support in PIX 6.2.

I have imported lincense in IPS 4240 that haveing one Temporary management IP address. In future IP address is getting changed for IPS. Could It make impact on same?

I am proposing PIX-515 Active/failover bundle with 6 interfaces in each box.Does the failovers box activated even a single interface (suppose DMZ #1) is down in the primary box ?

I applied IPS-sig-S182-minreq-5.0-1.pkg to my IDS/IPS 4215 with an inline interface pair. Immediately, I began receiving phone calls from users complaining that https sessions with outside app servers were extremely slow. I also noticed that one teln...

Greetings,I've noticed there has been a lot of repeat questions lately. I also note that, since this is not a moderated forum, there's really nothing here to guide new users on how to best leverage the information made available here.Here's some sugg...

Hi Im trying to set up a Vpn tunnel to a remote customer with a Zyxel.Im new in vpn and need som help in debuggingIve jused a IKE DES/3DES SHA/MD5 and pre-share config.Nothing seem to work.Debug looks like this:632247: Jul 1 16:40:21.977 UTC: IPSEC(s...

Hello.We have a consultant, who's telling us, that we can't have internet access, while we connect to our cisco pix 501.Is this true?And, if its not true (which I believe), can someone point us to the info I need to verify this, and or the command li...