Hello everyone!We have a Cisco ASA5555 with onboard 16 Gb of RAM. Though when we launch the device - it only shows 4 Gb. The ASA version is 9.14(4)24. Tried to re-seat the modules - no luck. Also tried ti switch to diffrent working ones from other 55...
Hello Guys,I have a cluster of Firepower 2110 with ASA 9.17(1)20, and I have ASDM 7.18(1)20. I want to upgrade the Firepower because of recent vulnerabilities on ASA.What is the recommended version for ASA ? I have checked on Cisco software and there...
Due to an error, an IT staff factory resetted a working FTD. The FTD was registered to a FMC with a valid licenze subscription. I have to reassociate my resetted FTD to FMC. Is there a way to do this without making again all configuration? I'd like t...
Is there a way to reconfigure the expired trial license on the Secure Firewall 4200 series just to operate the device temporarily? The issue is that the smart license has already expired and failed to load onto the firewall due to an internal issue. ...
Guys I am running cisco asav unlicensed but it is restricted to 100 Kbps. Please help me with the procedure to get demo license for it.
Hi, We have a Cisco Firepower 1120 and want to use some of the available ethernet Ports as a "dumb switch" to literally pass traffic through. We currently have (for resilience) 2 WAN NTE's which each plug into Cisco Router which in turn then plugs in...
Hello everyone, I would like to know if it is possible to implement Remote Access VPN on Cisco Secure Firewall while running in Evaluation Mode? I have already completed all the required configuration steps and enabled IPsec/IKEv2 with the DES algori...
Can someone provide me with the SKU information of the Universe Permanent License Reservation for the ISA-3000-2C2F-FTD series for offline deployment?
Hi,Is the FTD API available when the device is centrally managed by FMC or in this scenario we must rely on the FMC API only?Regards.
Hi allWe have a pair of ASA5516-X devices, running as an active/standby pair. Several times a day, the active device will stop forwarding traffic so all users lose connectivity to all data, applications and services. There is no error message in the ...
I have two FTD 1140ns managed by an FMCv. Both are running 7.6.2. I enabled portscannig in detection mode some time ago. I noticed quite a few of my local IP addresses scanning out to Outside (public) addresses. I know this is a nubie type of questio...
The "Securely Traversing IACS Data across the IDMZ Using Cisco Firepower Threat Defense Design and Implementation Guide" refers to the use of FMC as the management platform.Is there any reason why FDM could not be used? I am particularly concerned ab...
Hi, In FTD v7.6.2 I have and access rule to block incoming traffic with destination port ssh,rdp and telnet. but,upon checking the logs, traffics was block using this rule with destination ports for others not specified in the rule(dns, snmp,ldap etc...
Hello! We have many devices affected by the clock-signal issues. Cisco does replace the units with repaired/fixed ones. I have received some ISR4321 routers with the fix applied (pictures attached). The Cisco provided fix is of - well - mediocre qual...
Does anyone have release notes of the above release? The do not seem to be available over Software download, so I try it here. (v9.18.4.67 and below is available).
