Could anyone tell me what is the correct power supply voltage and maximum current consumption of the Cisco 1000BASE-LX SFP module # 30-1299-01? Thanks.
Could anyone tell me what is the correct power supply voltage and maximum current consumption of the Cisco 1000BASE-LX SFP module # 30-1299-01? Thanks.
I upgraded my Sonet 1545 this morning. The upgrade looked good. I was able to download, install and activate the software. I rebooted the ONS and now It will not boot. The lights just blink. I am not that well versed in this to determine how ...
Hi ,I'm working on a GNE and subtending NE setup with ONS 15454.When i run the COPY-RFILE TL1 command parallely through a script, I'm getting the following error from the NE./* ERROR - -5000 - FTP Error */Any pointers on the root cause of this error ...
Hi all, here is my delima. I have a CE-1000-4 cards with three provisioned ckts . Two provisioned as STS-1-2v, one provisioned as an STS-1-10v, Looking at the current provisioning, I should be able to increase the STS-1 count on one of the STS-...
Hello,I am still pretty new to the ONS product line, but have a reasonable understanding of the DWDM technology. I am looking to run two point to point dark fiber links between two colos within about 3KM of one another. Ideally, I would like to suppo...
Hello. We have many cisco 3560G switches running 12.2(46)SE. Several of the switches are on cwdm fiber links. We would like to be able to query the SFP's to see what their optical values are. I am told by a cisco optical person...
I have an ML-MR 10 card. I cannot figure out how to get the ONS 15454 to recognize it. I insert the card. I then the card and right click. I go to Ethernet and there is not an ML-MR Card. There is a ML1000 and an ML1000T. I really am not sure...
Hello all,I am looking to find out the different ways to check power levels of the different wavelengths using CTC. When I cable up the different optics on the CE devices, I want to be able to log into the CTC and check to make sure the power levels...
Hi ,We have a couple of these SPF transceivers which we have not use for a a while ie a year or two.Now we want to use them but how do we test it to see if it is still working ???ThanksQLE
I am in despeate need of some assitance in connectng to my 1545. We upgraded our software and now the lights on the 1545 just blink. I do not know if I can connet to this via the rs232 connection or not. I am not sure if somehow I can get the ...
We have a 4 node ONS15454 MSPP UPSR ring running 8.5.4 software. We are running the usual mix of DS1 and DS3 circuits, however I'm trying to standup some ML1000-2 cards to be used to transport some Ethernet circuits across the rin...
According to the TL1 document for 15454, COPY-RFile command denotes that FTP timeout is 30seconds and it is not configurable. I have the following questions on this.Is the timeout for creating a connection to the FTP server or for the total command e...
Hi everyboby,in the office we have 4 switches SG200-26 all connected ones between them in fiber.Only one however it has problems with mini-gbic SFP transceiver, if inserted it doesn't ignite any red light.Can he depend on a hardware problem only or d...
Hi everyone,I have two new Cisco switches connected to each other with a fibre cable.Does anyone know any CLI commands to test the fibre cable from any of the two switches?(I know there is the command "test cable-diagnostics ... etc". But, this only...
