Other Collaboration Subjects

If someone from an offnet phone calls into Unity, the volume of the subscriber's greeting is really low. The volume of the greeting when calling from another subscriber is fine. Is this a Unity or Call Manager issue? Is there any way to adjust the...

All,I'd like to send message from one IP Phone to other. May be someone decided this issue. I tried to use IP Phone tags, but it is no result.I appreciate your help.Sergey

I have installed CM 3.2.1 configured with MGCP ver. 2.13. The ATA is registered at the CM succesfully, second line is registered by shifting MAC address 2 digits successfully too. There is no dial tone at the second line and there is no way to dialin...

Unity 2.4.6<br>We created a call handler to transfer to the extension 1555. In the profile section, we put 1555 as the extension and in the transfer section, we check : Yes ring the subscriber at the extension (1555). Unity thansfer the call always ...

I just bought a Polycom FX that can do the multicasting to the IP/TV viewer. Can I get it to show up on Content Manager? How?Thanks!Steve

I have a problem with connecting with the PBX. The PBX phone cannot call the IP phone and neither can do the other way round. Just no response whatsoever. However, the E1 controller and the lines are up. My config for 3662 is:voice-card 2!ip subnet-z...

Our customer is experiencing low message volume on Unity messages when the caller came via the PSTN. Greetings and prompts are fine, as is the message level if the message was left on an IP phone. We have tried all the variations in the audio decis...

Need help for the following:The routers have been configured for VoIP. The voice interfaces are FXS, E&M and HDV-E1. The customers wants us to implement NAT.Can VoIP work if NAT is implemented? What if PAT is implemented?

2 sites, A & B, were running Unity ver. 2.4.6.135. From either site, we were able to create messages and add recipients from either Unity installation by using a sitecodes + 4-digit extension--100 for site "A" 200 for site "B".<br><br>Site "B" recent...

Hi, I need to find the cisco IOS needed to operate a cisco 7204 or 7206 VXR router as an GateKeeper. Can anyone send be the exact filename of the version required please.thanks.

Hey all,<br><br>Once again, let me start off by saying thanks for all the past help.<br><br>New question. In terms of disaster recovery. Let's say that we lost our Unity box and we wanted to recover it. Where is the subscriber information (extension ...

Looking for config help, if available, for terminating both voice and modem calls on the same PRI. Or, does this have to be configured so that voice is on one PRI and modem/data on another.Thanks,Michael Clendening

Hi, Can Cisco 7500 be configured as VoIP gateway? If yes, what gateway protocols will it support?thanks and regards,Silju

Looking for confirmation or denial that Host Intrusion Detection Software will run with Unity 3.0 (as Console and Agent). Should this be the case then I am looking for an Installation guide that will explains which signatures should be set at what l...

Hi,I have a PRI line from PSTN , the number range is 9990000 - 9990029. Does that mean that i need to configure on the callmanager 2 digit directory numbers (or translation patterns ).If i configre a DN 10 and call 9990010 it works, but the callmanag...