Other Collaboration Subjects

I want to use linksys ata i.e. pap2t that do support sip protocol. i wonder if it works will integrate with cisco cme. Actuallay iam having problem in ordering ATA as cisco have withhold ATA deliveries. Iam looking for cisco ATA alternatives. i have...

I am trying to install CUCM 6.1 on a DL380G3. I have the exact hardware as mentioned on the following link, but the setup wizard still tells me the hardware is incorrect and setup cannot continue. I am using a SmartArray controller, dont see that on ...

Who has the million dollar answer! We have a mysterious issue... or mayb not to some :)Our packets of voice are tagged with voice all the way along our network..until..it hits the data vlan then its gone! if we have a voice vlan instead on that inter...

Dear Pro:I have a unique situation, I have a CME 4.1 system and I have a ISDN PRI link, I am using 4 digit extension, when an incoming call from a user who is using analog phone, the last 2 digit of incoming call is missing, this is shown in 'debug i...

We have a service from a vendor that requires a "DevExt" parameter with the phone DN on the service for each phone.Is there any way to edit this so that it will grab the DN from the phone rather then having to specify it? If I could add something li...

Hi,How can I dial a phone number from my outlook contact list on a CISCO IP PHONE 7960 Series?Thanks,AC

Can some one tell me if there is IP communicator software(IP soft Phone) for mac's?

I have 130 users who have voice mail only. I set up them up with a cti route point and a voice mail box in unity. Since I created these I have been receiving the following warnings in the event log on Unity server(version4.0(4)SR1):Cisco Unity-CM T...

guys we have a rockwell ACD (PABX) which is connected to a cisco 2821 router via E1 card....the router is connected over WAN to a IVR server and the communication is SIP based. the router works perfectly but sometime we get calls from gusy who use PA...

Hello out there,Following problem:I need to have a call queue in CUCM BE 6 with music, BUT without using the attendant console!!We do not want to use the console.Situation is as follows: Calls come in, Unity Connection plays the welcome prompt (accor...

Hi guys, there is a local number that we can't dial with voip phone, it goes through maybe 30% of the time. Do you guys know of anything I can use to analyze the call or any ideas what the problem could be, we are runnig CM4.x? Phone number can be ...

We are on Cisco 5.1(1) and Unity 4.2. Is there an option in Callmanager for an "intercom" system? Our administrator would like to be able to have some type of intercom to "holler" at his secretary. :) Is there a feature or 3rd party app that woul...

Does anyone know what the issue might be with not getting a 7940 to pull a phone load from CME version 7.0, on a 2801. We have a mix of 7961's,7911's, and 7940's. The 7911 and 7960's pulled the new firmware but the 7940's will not. Here is the config...

I want to use the locale dictionaryIn localizedDirectory it has:var fileName = "c:\\ciscowebs\\ipphoneservices\\ccmcip\\locales\\" + locale + "\\ccmcipdictionary.asp";The server IIS, where run this script,it's different to CallManager.What do I do?Wh...