Other Collaboration Subjects

Im deciding on a voice router for my remote site...the site is connected via gige wan back to the HQ office...so i will prob run g711 everywhere...i have 14 POTS FXO trunks at the remote site...how many dsps should i get? its a 2811

Good Evening,I search a solution for night-service.I have a tcl autoattendant (cisco script) with ephone-hunt, but I want diffuse a message when office is closed. I have a little script playing a message.But How can use "call-forward night-service 99...

I have a customer asking an interesting question about how to set up backup PRI's for a new AT&T megacom Long Distance PRI that was recently installed. Currently, the PRI is configured as an MGCP gateway. In order for the gateway to support megacom...

Call Manager 5.0 with a SIP Trunk to a voip provider, does not pass calls. Performed a network sniff the SIP From Address is 029<>60@192.<>.220 the first part is correct but after the @ should be the realm of the account not the internal ip address ...

Anyone familiar with CLI commands for CallManager 5.0 running on LINUX?

I want to communicate between Cisco CallManager & Ericsson PABX with IP card in two different siteThe two sites connected via Cisco 2811 voice bundle routerAnyone can help with sample configuration ?RegardsMohamed

Straight out of the box, the menu on the 7920 allows you to choose a different ring tone, but the actual tone remains the same. Is there anything else that needs to be done, like using the Configuration Utilty, or even on CCM4.2, so that users can ac...

how do you configure the as5350 to collect cdr records into a server? what commands do you use?

Hello:I know how I can make a call forward for all my inbound calls, but How can I do it only when I am busy or when I don?t answer the call?thank you

I am having a remote user trying to make a dial up connection ( data )via analog line terminated on a VG248 device but he is unable to make the connection the same user when he trs to make a analog voice call via VG248 he is able to make the voice ca...

Hi guys;As we know FXO is an analog access gateway and there are other of modules carrying E1 digital channel,my question is that I need to know:what scenarios in which I should use FXO and what scenarios I should use E1 module?if I have a CCM and I ...

i test my application on IP Phone 7970 i get an "XML Parse Error 4" what does it mean?i develop my application by ASP.NET(C#)

Our main Avaya PBX medpro lan cards are connected to a 3750 switch, 100mbps/full duplex, running 12.2(25)SEA. This PBX will have a maximum of 300 G.711 calls going through the medpros and I've configured Auto Qos and mls qos as shown below on the po...