Other Collaboration Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Trying to load CM 4.0(1). Start with the Hardware Detection Disk1. Enter IP address, GW, etc. Then it asks for Disk3. I put that in, it begins to copy data, reboots and eventually asks me to change the password. I change it, and when it prompts ...

wupchurc by Level 1
  • 364 Views
  • 1 replies
  • 0 Helpful votes

I have set up broadcast ring within one of my departments. Their main phone rings and rolls to the Broadcast number. I have it set to brodcast ring for 60 seconds. I want the call to go back to the main numbers voice mail after the broadcast if unans...

Hi,We have CCM 4.1(3)SR1 and we have '9' configured for outside line.When there is an incoming call from lets say XXX, caller ID shown as XXX and this is also the way it's entered in Missed/Received/Placed calls list.Without a preceding '9', it's imp...

dknov by Level 3
  • 466 Views
  • 3 replies
  • 0 Helpful votes
Top Solution Authors