Other Network Architecture Subjects

when i say no shut it gives me the folloving:Router(config)#int fa 0/0Router(config-if)#no shutRouter(config-if)#00:02:42: %AMDP2_FE-1-INITFAIL: CSR0=0x0000Anybody help me please?

hello. I have a problem with a cisco 2600 router. in that router I have two T1 internet conections. each connection in every serial port. well... the problem is..: when both conections are working at the same time my conection speed is 100 Kb/s!!when...

Hi, we have 3 switches (A,B y C), Switch A is conected to switch B and C.We have some QNX servers and clients conected to this switches, but some times the clients can't see the servers, o the clients can't see the others clients, this is just for fe...

This may have been asked/answered a 1000 times. I have a 1721 router with a WIC 2AM. I want to use one of the modems for dialin OOB management purposes. How do I configure the line?

I'm currently preapring to use SVIs for my VLAN interfaces, but realized that the model #'s of my switches reads Model number: WS-C3550-24-SMI. From what I've read I'll need an EMI image in order to support layer3 SVIs (instead of RIP). Is this a s...

Already submitted this Q to the "ASK THE EXPERT-CONFIGURATION/DEVICE MANAGEMENT WITH CISCO NETWORK ASSISTANT" forum - They just told me it's a switching routing forum question so here goes...I have 5 new 2950's and 2 new 4506's, all running the same ...

Just wondering if HSRP Ver 2 is considered to be ready for production, or still to new for a production enviroment.Thanks.

I have both in the same switch with CatOS. I reviewed the requirements of CatOS, IOS and bootstrap and the box is OK. The box work very well with the SFC2 or the FWSM, but with both of them togheter it does not reconogcize the SFC2. I guess I missed ...

Hi...I am connected to a remote site via ATM link via the central site. I am trying to connect to a shared printer on a PC in the remote site using \\x.x.x.x (IP address, not the PC name) but still no luck. The setup is as follows:Site A (central sit...

I have a problem with an old AS400 box (maybe 15-20 years). We recently upgraded our routing from a route switch module in a Cat 5000 to a 3750 12G switch. The problem is the AS400 box on the network has the correct IP configuration but nobody can ...

This is a sup2/msfc2 running native 12.2.14 SY5 . When I try to set up a span to monitor ports 3/1-48 to port 3/23for both directions it comes up with a message % This platform allows a maximum of 1 TX monitor interface(s) . Anybody else ever se...

Hi,I'm getting many input and CRC errors on a 2950 that is connected to a 6509 on 1000SX ports. This is happening with all new VLAN's we create, however, old VLAN's configured on the 2950 have no errors. The 6509 is also showing Rcv-errors. I thin...

We had a very strange problem today with out switches. First I will start out explaining our environment a little bit. We have a Cisco 4510r with 4 48 port GB modules which houses most of our servers. We also have about 6 other 100MB switches of v...

I was wondering if anyone knows of a resource from Cisco or elsewhere for developers wanting to create programs that issue commands remotely to Cisco devices via SNMP.