Other Network Architecture Subjects

Hiya, I have the following kit:- WS-C6006 Software, Version NmpSW: 5.5(8) Copyright (c) 1995-2001 by Cisco Systems NMP S/W compiled on May 15 2001, 15:06:17 System Bootstrap Version: 5.2(1) Hardware Version: 2.0 Model: WS-C6006 Serial #: TBA03360148 ...

Hi, folks!I connected the twelve switches 2950G like file attached.But I can´t pass more than a VLAN from sw-1a to sw-2a, sw-3a and sw-4a, the same from sw-1b to sw-2b, sw-3b and sw-4b.So, I need the same two or more VLANs(id 1,2 e 3) in switches sw...

attached document: i need the LAN A user to access the internet from Router C.I need the routing and natting command on each router. can any body correct me-------------------------------------Router A---------Ip route 0.0.0.0 0.0.0.0 bri0Router B---...

Hi all.We perform broadcast storm control on our 6500, with set port broadcast command.Now we have added a 10/100/1000 line card, and if we perform the command above, it print an errorcommand not supported on this moduleAny idea?ThanksDaniele

Hi allCan someone please answer me this.I have 2 networks, one is 10.0.0.0 class A, the other 172.19.56.0 class C. How come when I put a static route on the 172 router, the route being 10.1.0.0 class B going to the router on the 10.0.0.0 network it ...

I want to ask my user access internet or intranet by DHCP user.If the user who get IP address is not by DHCP srver, it is forbidden to access any information. How to configure it on 3550?

Hi forum !I have a little problem here.I have some VLANs on my LAN and i need to put them in a Q-in-Q, so i can pass those VLANs trough my SP's MAN and deQ-in-Q the frames out to a remote office.My SP is givving me a trunk, which i connect to a GBIC-...

I apologize for the swarm of questions, but we're getting ready for a major upgrade and I'm just trying to get some clarification on a few things.DHCP snooping we've tested on 3550s, and it works great locally. We then figured out, in installation, ...

I have some Cat 4503 switches (S2+) linked via 1000BaseSX connections. One switch is at the centre with a WS-X4306 card, and another three uplink to it via their supervisor cards.I did a show interface counters all recently, and I notice a large num...

I have a catalyst 4006 L3 switch which uses catos for the l3 ports and ios for the l2 ports. the 4006 as a supervisor engine 2 blade and a 4148-rj blade. I would like to remove the catos from the switch and use only the ios. Any problems with doin...

What would you guys suggest for implementing VLANs. We have a 1841 router, we have about 200 users. What switch would you suggest? we dont need anthing to extreme. And im running IOS 12.3 on the 1841 does that support ip helper? I cant seem to find i...

I cannot get an Intel 1000 MT NIC to negotiate at port speed 1000. I have tried using Auto on both sides and hard setting the port speed. I have even upgraded the driver. Any ideas out there?Thanks,Forest