Hi,Was wondering if someone had some time to review my outline for upgrading one cat 6506 with 2 sup cards using cat os cat6000-sup2cvk9.6-4-16. Is this version ok? I'm running 6.3(4). At the end of June , I will be migrating the secondary cat 6506 ...
I have a 3550 with a bad configuration. System stops at Press Return to get started. I press return nothing happens, no login prompts. I tried the the recovery procedures by reloading new OS via xmodem, copy completes but original config still bad...
Hello,We are running s72033-ps-mz.122-18.SXD4.bin, sup720 card.First issue:Configured switch, boot command as well. (boot system flash sup-bootflash:s72033-ps-mz.122-18.SXD4.bin). Wr mem, reboot, ios image was loaded.But after 'wr erase' and reload, ...
Dear Cisco folks,the 'show controllers' command in a 2950 with IOS 12.1(13) shows counter going up for field 'Single Defer Frames' , but not for 'Multiple Defer frames' or any other errors in the Transmit or Receive statistics.These 'deferred' frames...
Hi,I have a customer network which is a layer 2 implementation.The simple schematic is multiple 4500 --- 4500---3500 XL with layer 2 connectivity and trunking between them.One question that has been raised is can we have the 4500---4500 connection on...
If I create a service policy that has policers in it and then attach this to a VLAN interface (as opposed to a physical Interface). Does the policy look at each interface individually or as a whole? i.e. the policer for a class is set to 32k (polic...
ok I have setup span ports before with no problemsbut when i setup a span port on a 6500 i only get 1/2 the conversion..exampleping the 6500 from the workstaion and I only see echo replys from the switchping the workstation from the 6500 and I see e...
Hi Guys,I'm trying to migrate a 3550 switch from VTP domain and at the same time also from client to server mode .I want to do this by placing a new config in the startup and then rebooting the switch .I gave the commandsvtp mode servervtp domain new...
Dear All,Is it true that 10Gb Uplink will actually be worst than 1Gb Uplink for low-utilization users?Your early response will be hihgly appreciated.REgards,Azmath Khan.
Hi,If you want to connect two switches together using two FastEthernet ports on each switch, what is the difference between using two straight trunks and using the two trunks to form an FastEtherChannel?When I configure the two ports on each switch a...
We are an all Cisco shop with 3500XL at the edge with a 4006 in the MDF at our remote locations. Every once and awhile we lose a site because of a $30 hub or switch that has an auto uplink port in it plugged into a 3500XL. In some cases a user has pl...
It has been years and years since I have had to deal with IPX (lucky me). I have a single novell server running 802.3. It will be local lan traffic only. I am running 12.2 code on the MSFC, 12.3 is not released yet and 8.4 on the superviser l2 portio...
Hi Guys,I am using Cat-6509 with CATOS- cat6000-sup.6-1-2.bin. Switch is configured with around 20 Private VLANS and switch is acting purely as L2 Device.Now the problem is that whenever I try to delete any PVLAN on the switch, the switch gets hange...
