Other Network Architecture Subjects

I have two routers in my network who's free memory count decreases every day to the point where I cannot even telnet to the router because of insufficient memory. A reload of the router gets the free memory count up again but the loss of free memory...

I read a statement in the 2950 LRE documentation indicating that the OS supported 8 port Etherchannel on the LRE ports. Since the 585 only has 1 dataport and 1 phone port how is Etherchannel possible, is the phone port configurable?Is there a situati...

Hello, My customer, an ISP, brougth to me a lot of soho 77 and told me those are damage.My question is May I connect two of those soho 77 (in test mode) via its ADSL Ports??Thanks

I would like to figure out the best way to load-share or load-balance two T1 connections so that we can fully utilize a 3Mb pipe to the Internet. Ourcurrent setup only utilizes one of our two T1 lines. Here is our following setup: SprintRouter2 - 265...

Hi guys,I had a problem with my RSM module yesterday, when it suddenly showed me RED on the activity LED. There was no reboot of the RSM or the switch or any power fluctuations. All this happened , all of a sudden. Even when i reboot my RSM, it gives...

I have a Win2k Server with an Intel Pro 1000 MT Server Adapter that supports 802.1q. This server is connected to a 2950T on one of the two Gig uplink ports. The switch port is configured with:switchport mode trunkspanning-tree portfastI'm typing th...

I am configuring SSO with NSF on a pair of Sup720s, running 12.2(18)SXD3. Is it correct that the running configuration in this scenario isn't sync'd, even if the "auto-sync running-config" is added? When failover occurs, it appears that the standby s...

First question , what commands are needed to activate this on a Sup 720 running multiple different distributed forwarding cards , previously you just had to put ip route-cache flow on the interfaces , then do a show ip cache flow to look at it .W...

To install 6509 module, I have two steps that push the module into 6509 and lock the lever.The problem is all packets drop on the 6509 when I push the module into the switch and restore when I locked the lever or remove the module. Usually, we are pu...

Anyone could help to acheive the following I want to nat source address of packets that is originating from router itself (ex: tftp request and dns query etc..) Is it possible. Where can I put Ip nat inside ????

Hi,I need to configure a CatOS-based Catalyst for it to only allow the following command when accessing via Telnet:show arpI have created a user with the command "set localuser", but now how can I define that this user can only use the command "show ...

hi , could any one tell me what does this access list means ???access-list 90 permit 0.0.0.0access-list 90 deny anyRegards

We have about 15 Compaq servers with double serverNICs with Intel PROSet. We are going to connect these servers to two C3750 stacked with StackWise, one NIC on each C3750. Intel PROSet supports loadbalancing via LACP, but the switches can only have a...