Is there any way that I can know how much time a port has been idle or at least the last time it was used?Thanks.
Is there any way that I can know how much time a port has been idle or at least the last time it was used?Thanks.
We just setup a ftp server behind the Cisco router 831. We find that we can use SDM to access the router from any public IPs. Can we limit it to a range IPs? From the telnet command lines, I can't tell which is for managing accessing SDM. However, fr...
Is there anyway to save reports in a pdf format instead of the default CSV format?
Why cisco call his switches the catalyst. Is there any special meanings in this world. I mean i want logic of cisco for calling catalyst to his switches.
HelloA customer is using X.25 to TCP/IP translation with a Cisco 2620XM router, which works properly when only one X.25 VC is active.Using two concurrent VCs, the second X.25 connection cannot be set and switches continuously from established to clea...
Two questions regarding the RPS (Redundant Power System) and Catalyst 3750 switches:1. Does anybody know whether or not Catalyst 3750 switches work with RPS 600?2. If I use RPS 675 to work with 3750 switches, can I connect the RPS and the switch to d...
I am using 2610XM. I want to go to Rxboot mode for this i have changed the config register to 0x2101 but when i restart the router it still going to the normal user exec mode of full IOS(no RXboot). Why is this happening however the same register val...
Where can I find a datasheet with the capacity of the 1760 (fast switching)? How many pps is it?
Hey Guys, I need to configure a 2600 running IOS Version 12.1(20) with a dial up connection. I need the connection to be the receiving end. Can anyone help me out. Thanks.
Anyone knows if the Catalyst 3750 supports NAT?Thanks
%SYS-4-SUPERVISOR_ERR:Forwarding engine IP length error coutner=xxxI noticed there has already been a question posted concerning this error. However, there is no detail in the system message guide referenced in the answer that gives any hint about ...
Himy 5350 is rejecting incoming ISDN calls (which should be routed to H323) with cause 'Incompatible Destination'. When I turn on isdn debug I see the following error01:46:09: ISDN Se3/0:15 **ERROR**: call_incoming: Received a call id 0x2E with a bad...
Hi guys,We have a CISCO 2610XM router w/ NM-8AM module serving our remote mobile dialup users.The server works fine until recently wherein the modem seems not to answer anymore the incoming calls (no handshake). Sometimes the modem answers but only w...
I have a hub & spoke frame-relay network. All remote offices connect to a frame router here at the corp. office.From the remote office I'm trying to place extended access list to manage outgoing traffic. Instead of denying certain traffic I want to a...
HelloI'm deploying some 6509 switches with SUP720's running 8.3.2.I've noticed that the CPU utilisation is always at least 15% (usually taken up be IDLE_tasks and SlcpProcess). However this constantly fluctuates between 15% and 80% just by performin...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
07-17-2024 06:07 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |