A collision domain confines which of the following: A. Frames sent between devices on interconnected LANs B. Multicast Frames C. CGMP Packets D. Frames within a switch E. Broadcast Frames
i have setup point-to-point frame relay subimterface in my router i'm using mannual resolution what command can i use with my subinterface to assoicate the dlci to it? A- frame-relay interface-dlci B- frame-relay map C- frame-relay interface-dlci or ...
I am trying to get the serial numbers of GBIC's from a 6509. I have been told that the command "sh idprom interface gigabitEthernet 3/8" will give me the serial number but I get the following. "GBIC is not security enabled". Does anyone know the comm...
Hello All,I am trying to setup netflow collection on a CISCO 3750 running 12.1.9EA1d without much success. Netflow configuration is straight forward i.e.int fastethernet 1/0/xip route-cache flowis all thats required ( for a simple config )However whe...
Can anyone quickly tell me how to encrypt the session passwords? For example: In the config all the passwords under - Line CON 0 and/or Line VTY 0 etc I remember there being a command to encrypt those.
hi i have found that Cisco 2610 has different models like X. something. Will anybody guide me that what are all versions in 2610 model and what is difference and how can i found that what is the model no of 2610 router upon seeing the router. i mean ...
Hi All.I want to connect two LAN in two different buildings(<200m distance). The LANs must be connected through a fiber link and a leased line(copper) link between these buildings that both link must be used. What is the best deployment with this sen...
Is there a patch for this malformed packet, or are there going to be upgraded IOS versions for each platform - type solution? I got the impression, when reading the bug info, that the solution is to wait for these upgraded versions. Just checking. ...
HiCan anyone tell me if there is a certain procedures to connect to console on 2924 switch ? I have tried using hyperterminal ( normal way) won't work ! I was told to hold down the mode key during power up for 15 secs ? any one know the correct metho...
A port SPAN is created recently to monitor the traffic on another port on the same 6509 switch. This is the configuration:set span 8/28 8/19 both inpkts enable multicast disable create8/28 is the source port, and 8/19 is the destination port. Port ...
Any clues as to how to save the running config in a router via the aux port?I know about a flash image, but while connected to a router via modem-->AUX port, I need to retrieve the config and save in my computer. Any assistance will be greatly appre...
The hub can ping the tunnel interface on the spoke and the spoke can ping the tunnel interface on the hub. However, I cannot ping anything on the LAN side of the hub or the spoke. Has anyone else had this happen to them? If so, what did you do to ...
