Other Network Architecture Subjects

Hey guys,I have a cisco 2950 and it has a pretty basic config on it and about 12 to 15 access-list. The problem I am having is sometimes I can't run commands on the router due to a 'command buffer is full' error message. This doesn't happen all the t...

fail debug*Mar 1 02:21:37.359: ISDN Se1/1:15 Q931: RX <- SETUP pd = 8 callref = 0x0065 Bearer Capability i = 0x9090A3 Standard = CCITT Transer Capability = 3.1kHz Audio Transfer Mode = Circuit ...

Hi we are currently converting our network from Frame-relay/OSFP to MPLS with e-bgp. We are redistributing the MPLS e-bgp processinto OSPF. We want to leave the OSPF frame network in place as a backup for the time being. The problem I face is that th...

We have atm router 7200 which is connected trough atm cloud to one more 7200 in other end.every thing works good except one thing !!!Files which has characters 95E2 will stop in meadle of copying from one side of atm cloud to other side.as I know its...

I have some dell computers that will not maintain a connection to a Cat 3524 switch. I have upgraded the flash and totally redone the config. I have also manually set the interface and the computer to be 100/full. The interface resets about 45 tim...

Cannot create install dependency file, error on "jrew_dep.exe"Please help...Thanks

Hello,I want to have 6509 CatOS (8.8.3) and MFSC configured for SSH (VTY/transport input ssh). Then I can't use anymore the command "session 15" from switch as this command seems to be a telnet to the MFSC card.If I enter on MFSC, "transport input te...

We have Catalyst WS-C2950-24. It works like normal.But, if we connect new equipment on FastEthernet port, there is a following message: 00:01:00: ERROR in strata_protected_notify:line935: can't get remote inst pointer That it could be and how of it...

HiI'm currently looking at upgrading my two Cat 6513's from IOS 12.1(11b)E4 to 12.1(23)E. My feature set is SP W/VIP SSH 3DES and I have the following modules installed...Mod Ports Card Type Model Serial No.-...

Hi all ,I want to write an application using C#.Net Can you please recommend a library / API for .Net ?Any other SNMP application Building tip will be welcomed!Thank you!Sharon

hi,i've got some questions again...when you type a " show int xyz " there is a value called reliablility. hopefully it has a value of 255/255 which tells you, that you had a reliability of 100 percent the last 5 min in average.but how is it calculate...

hi,i've got a short question.when you type a "show int x" there is a field called reliability. hopefully it has a value of 255 of 255 which would mean that you had a full realibility of 100 % in average of the last 5 min.but how is it calculated ?err...

Hi NetPro,Currently,i am in vlan 30 (10.30.30.x) and my server farm is segment 200 (10.200.200.x), and from the segment 200 running dhcp pool which is 10.210.210.x .i got no problem to ping and access from segment 30 to segment 200. and i did the rou...

Hi all ! I have a network topo described below: - LAN network connected to SW3550. - SW3550 connected to Cisco3735 by ethernet. - Cisco3725 connected to 2 external ADSL_MODEM to 2 different IPS for backup and loadbalancing purpose. links and routing...