Other Network Architecture Subjects

Having great difficulty configuring these devices, has anyone set up these cards back to back. I would be interested to know what cables are used, in some of the documentation it describes a Y cable at the CO end, has anyone had to use or make one of...

Hi,I have a customer who would like to buy SNMS 1.5, but does not want to downgrade his server to Win2K. If SNMS for Win2003 would be available within two months, he would like to wait for a new version.Anybody out there knows if SNMS is planned for ...

I have two T1 lines terminating in to 2 router. One router has one t1's and it is connected to a pix. Another router has one T1 and it is connected to another Pix. I wanted to make outbound redundancy so that if one T1 goes down the other T1 picks up...

Hi everyone,I'm studying the OSPF routing protocol. I've done some lab to illustrate some thing in book.I established OSPF between 2 router. When I used loopback interface, the router ID is loopback interface (right with the book). But when I disabl...

hi,i configured a 2950 as vtp client. once, on this switch a made a delete flash:vlan.dat.i did a wr, and each time i reload the switch, it comes back to vtp server.can someone tell me why??thanks.

Hi all,I have LMS 2.1.i have question that do i need to purchace an update to convert it to LMS 2.2.Can i download the updates from the cisco site ?If i can then from which location and which file is required.Currently i have CD one Fifth Edition ver...

Is the upgrade from 3550-SMI to EMI just a software upgrade or is there also an upgrade required on memory etc..?Thanks,Guy

Can a T'1 interface on a 1751 be configured with more than one Frame Relay PVC? Does it use sub interfaces? What is the max number of Ethernet interfaces availabe on the 1751?

Hi,I'd like to know a way how I can figure out what IP address is connected to a specific switch port.So I know what PC is connected to that port.anyone knows a good method ?greetings,

Can we do layer 3 command in the CatOS version i.e no switchport,ip addressing?If can, what is the command or if cannnot what are the solution ,do i need to change it to IOS version?

When I am configuring a new 2950 switch, I sometimes copy and paste various parts of an existing config from another switch. As a matter of course, we tie down all user ports to 10Mb/Half, unless there is a good reason for them to run at 100Mb.If you...

please let me know ,What is the diference between Enhance ethernet and normal one?thanksRod

Hi,I got a no# of routers running IBGP, with one of the routers connecting to the ISP. But I am using static routes on my edge router to the ISP router.So my requirement is that I want to let the edge router to inject a default route to its peer via...