Is there a way to change the telnet password on a cat 6500 with catos 7.4.3 if you know the snmp read-write string ? If so how ? We normally change this thru ciscoworks but it fails saying the password is wrong . We then tried to doing it from the CL...
Is there a way to configure a terminal server (3660) line to ignore a reboot, that is, to not disconnect? The problem is that by the time you log back in, boot-up messages are lost. This is particularly a problem with Unix based servers.
Hi all,I have one question specific to OSPF controlled router shutdown.In ISIS we can take a router out for maintenance purpose by setting set overload bit command. Is there anything similar command or method existing for OSPF? which allows to take t...
Hi guys,I read an input (article) on the above subject in the latest edition of packet and I must tell you that is what I have been looking for.I tried the config on my 1751-V router with IOS 12.3(9a)The IOS is a an Enterprise base (c1700-entbase-mz....
Hi all,The EssentialsDbMonitor and CmfDb monitor failed to run after I installed RME3.5. Tried to start them and got the following error message:{EssentialsDbMonitor}: Cannot connect to 'rme' database, please contact your system administrator.Also, t...
Hello,I'm having a problem with a catalyst 2950 switch ,when i try to paste an access list to the swich getting the following error " %Error: The field sets of all the ACEs in an ACL should match "The IOS ver 12.1Please note that the same access list...
Hi all,I have implemented a lot of access lists, rate limiting, etc. in the last few weeks on a c2650, and would like to see how the router is doing. I have not seen any slow down in connectivity speeds, but I want to know how badly the router is be...
Hi,I work in a fairly large network with a pair of Cat 6513's with MSFC-2 in HSRP mode at the core. Cat OS Version 7.4(3) and IOS version 12.1(13)E6 on the MSFC. The access switches are all Cat 4507's with Sup IV modules with IOS version 12.1(13)EW....
Hi everybody,I have ciscoworks2000 on w2k server. (RME 3.5)So when I want to have archive for one device by: Configuration management -> search archive by device, I have one error message (see conversation title). It work properly for other device.Al...
Using ip helper-address on a Catalyst 3750 LAN SMI no longer seems to work. In the attached config we are trying to get DHCP requests passed from VLAN 5 to VLAN1 (the default). Sniffer running on both sides tell us that the UDP packets are not passed...
Hello,I noticed this morning that on one Catalyst switch (CatOS 7.6(7)) I have a lot of messages :SYS-4-SUPERVISOR_ERR:Forwarding engine IPX too short error counterAccording to the doc., it seems that the errors counters have incremented. However, I ...
iam having here a 3550-12t. I created 2 vlans for the user (vlan 10, vlan 20) ive put an ip address for the vlan 10 but why i cant ping it even from the switch itself. is there something missing on the way i configure it? int vlan 10ip address 10.10....
Hi all!A customer wants to set-up a WAN simulation, therefore i have configured a Catalyst 3550 with 4 different vlans. The idea is to police data traffic ,when it wants to cross the VLAN border (= enters the virtual WAN), at 2 Mbps. I had configur...
Hello,I am looking for alittle design guidance for a project I am about to undertake. I am getting to the point of needing to add a second second subnet to a network which currently is one flat network consisting of one private range class C network ...
