Other Network Architecture Subjects

Does any one run into this problem?I just upgrade IOS on my 2651XM router. The version I upgrade was c2600-is-mz-122-24b.bin. After I upgrade sucessfully, the router no long see my 16 ports fastethernet. I did show int, I could not see the fasteth...

Does the modules WS-X6748-GE-TX, & WS-6724-SFP support local swichting by default ? OR Should I install DFC card to support the local swithcing ???RegardsMohamed

Hello:I have a 3640 router with 4 wic-1dsu-t1 cards to connect 4 remote offices. The problem I'm having is that I need to have on the 3640 the same subnet on the fastethernet side in order to connect the 4 remote offices to my LAN. Every time I confi...

we have a 2MB * 3 Links between two sites having cisco7200 series router IOS(12.3(8)T3).the links configured on eigrp are working fine but when binded on multilink the traffic doesnt travel on the multilink .would appreciate if somwone could help me ...

This is a part of the show ip bgp command output:mfr-3662#sh ip bgpBGP table version is 23451883, local router ID is x.x.x.xStatus codes: s suppressed, d damped, h history, * valid, > best, i - internalOrigin codes: i - IGP, e - EGP, ? - incomplete ...

I have a wireless cisco switch that I hooked up to our internal network but how do I configure it so i can connect to my network?thanks

Hi,I have a Cisco 1721 router. I'm changing the config. We just got a Watchguard Firebox X500 in and need to change the Cisco router config to accept the network changes.I'm curious if what I change in the router config is correct. Basically I wan...

We have several CISCO Cat 4006 and connected the Ethernet management port to the network for the network monitoring purpose. Recently, we have received a hugh warning emails indicating that these cat were off and on again after 1 minute. Did we use t...

HI allWhats the process to load missing MIB in ciscoworks.Below is the MIB i need to add in NMS Specific Object Information Object locIfInCRC OID 1.3.6.1.4.1.9.2.2.1.1.12 Type INTEGER Permission read-only Status mandatory MIB OLD-CISCO-INTERFACES-MI...

Im looking into a solution for isp redundency. Does cisco offer something like fat pipe. I have a t-3 connection to my one isp and would like to have another t-3 to another isp. Any suggestions would be appreciated.

Does anyone use their CISCO switches/catalyst as their network DHCP server? If so have you ever tried to build client machines with microsoft RIS on different subnets? We have tried everything and cannot get it to work unless we use one of the Micro...

Can someone please tell me what is advantage and disadvantage of having IP CEF configure on your routers? I am thinking about set it up on 2600 series routers.Thanks

How can I give a user access to the running config (sh run) except some of the lines (which contain the passwords) ?Thanks,C

Hello all,Recently, I installed some brand new Sup720. Some days ago, I noticed that when an interface goes down and up, it isn't logged. I have no message localy and nothing on the syslog server. The strange is that other messages are logged, like r...

I've asked others, but noone seems to be able to answer my question, so here it goes..............In each building of our campus we have 2 3750s that are stacked together. On each floor, we have a 2950G with 2 1000BaseSX connections to the building ...