I can find physical dimensions of the 3750 switches but I can't locate anywhere the additional depth needed to accommodate the interconnect cables without damage.
I am using a NAM and during a capture and each packet is tagged with a date that is way off. The Catalyst and the Nam dates are accurate. What did I miss?
I'm trying to find any documentation that describes the maximum number of tracked interfaces per HSRP group (or per interface). Having more than 10 tracked interfaces doesn't seem to be a good idea but I'm just looking for any info, if there is.Thank...
I want to limit traffic bound to specific subnets to 10Mbps. Scenarios as belowSource networks are 10.1.1.0/24, 10.1.2.0/24 and 10.1.3.0/24. Where as destination networks are 192.168.1.0/24 and 192.168.2.0/24What I want is, limit the traffic rate for...
hiWhen doing a show frame-relay pvc xx on my frame relay connection running traffic shaping. I see a substanial amt of late-dropped out packets. The link is a satellite link and i run voip over it also. Any suggestions on how to reduce the numbertha...
I found a ton of MIBs on this web site, however, the link to a .zip file that has all Cisco Mibs has been moved. It is much easier to download all the mibs in a .zip and then compile only the ones I want than to download the individually.Is there no ...
I am doing research on GLBP running on a 6509. I saw that it is supported when running Native IOS in version 12.2(17d)SXB. Is it also supported when running Hybrid with 12.2(17d)SXB on the MSFC3? Is it supported in any version for MSFC2?
I have a customer with 4 3550-24smi switches in a closet. One GBIC port in each of the first two switches contains a 1000sx GBIC uplinking remote closets. Each of the four switches has a Gigastack module for uplinking the switches. Having these fo...
I'm running a 3640 with IOS ver 12.2(7) and have forwarding of port 80 from a public IP to a private IP. There is no ACL to prevent port 80 on any interfaces. Ths NAT/PAT config is as followip nat inside source static tcp 192.168.51.74 80 203.xxx.xxx...
I can ping but can not telnet to a CSS box behind the firewall.DescriptionI have a Cat6500 with FWSM and MSFC that represents the internal network. The FSWM forms the no Nat firewall between the internal 10.64.0.0 network and the 10.66.0.0 "tools" n...
We have a Supervior IV/4 and a 4500 with Gig to servers and 10/100 to clients. The clients are experiencing intermitent timeout errors on the outlook clients connecting to the exchange server. When the client is on the same VLAN, the problem disappea...
Does anyone know if the C2950G will be replaced soon?The C2970G is for highend needs and not exactly a replacement.Will there be, says, a new C2950G alike with SFP ports instead of GBICs?
Hi all,I confiured default vlan routing Interface as a bridge group. Then CPU utilization went up highly. So I disabled the bridge group and reload msfc. After booting, The default vlan routing interface doesn't work . but Interface status is normal....
