Other Network Architecture Subjects

Dear Sir,We have a cisco 3745 router with the below listed hardware configuration.Problem is we are not getting access to configure CE1/T1 Pri module.Is it a software bug.When we run sh-techsupport we get the slot details with the card details for E1...

What is the best way to implement compresion in software based VPN (IPSEC) and how to verify does it work if there is no hardware VPN module?Is it funcionally to setup frame -relay payload compression on frame relay point to point even if there is IP...

Good morning,We have a frame relay network with fractional t-1 and 1751 routers. Over many of our links, we seem to be dropping connections or experience slow response times if only for a second or two, which makes all the difference in the world for...

Hi All, i have LMS 2.2 Bundel, after installing LMS 2.2, Wether i hv to install CD 1 or itis already there. pls give me suggestion.Thanks & Regards,Ciscobuddy

what are differences between VWIC-1MFT-E1 and VWIC-1MFT-G703?

HI I have found that on a 3662 with 3 NM-16 modem banks that at random the router resets the line config ( I think ) to its default values and they are shown in the running config. This happens to three of the modem banks the other one does not have ...

I am having some problems getting any help with this issue. I have a switch and am unable to get the password. Had I of known it was going to be this kind of run around I would have never purchased it!

Do they make/does the router support fastethernet modules?I have 2 10mb modules that I would like to replace with fastethernet modules.Thanks

I'm not able to connect our LAN to our ISP with the Cisco 837 Router. The ISP tells me the won't support Cisco and that I need to use the modem they sent. I don't want to use the modem they gave me. That's the whole reason why I got the 837. DOes...

I was hoping someone could point to a white paper or a best practices document that would give some guidelines as to when it is a good time to break-up a broadcast domain.I have about 3000 IP nodes on my network and all are in the same subnet. All n...

Have a set of four 3550 PWR switches stacked together using gigastack mods.Uplinks are Gigabit Ethernet modes in switch one and three. For somereason a gigastack module in one of the switches will shut itself down (interface is administratively down...

Hello:In 3550 with the version 121-20. EA1 there does not exist the command " ip verify Unicast... " On the other hand if in in other one that has a previous version 121-13. EA1a. How it is possible to to activate the unicast RPF in the first case, i...

I am deploying 2 5509 switches in a School, (donated items)...but one of the switch just wont boot past the loading of the 24 port eth modules.does anyone have an insight to this issue.my Hyperm connection is 9600, 8-N-1-NEnter password:2004 Apr 06 1...

Already checked the bugs reported, didn;t find any match .Any similar issues ?C