Other Network Architecture Subjects

My daemons.log is over the size limit even after backup and reboot. I am getting some of these errors:ERROR: CORBAREGISTRY:Unable to connect to ManagerControl object. Reason: org.omg.CORBA.BAD_PARAM: minor code: 0 completed: NoIt is also full of...

Hi,We have CiscoWorks 2000 with RME 3.3 running on Solaris 2.7.When I am trying to add a device using RME, the device stays in pending mode for ever. Has anybody experienced this before?. It was working fine before I reinstalled Solaris and Ciscowork...

Hi Guys,i got a questions regarding loadbalancing on Cisco routers. say, I have two locations( SiteA and SiteB) connected by two E1(LinkA, LinkB of equal cost) Links and i am using load balancing on these two links. i am using VoIP between Site A and...

Hi, If I have a single(default) STG configured and later on introduce a new Layer 2 switch and connect it to the existing LAN...Will the introduction of the switch bring down the entire network ??Will the switch automatically learn the topology and ...

Dear AllIs there a way to monitor and draw a graph for the utilization of the FRSM ports, on the MGX 8850??From my point of view that dspportcnt gives the immediate utilization ....Thanks a lot

Does anyone know if its possible to be able to use OSPF on a 828 router?

Hi,I would like to know how to retreive (in a text file) the mac adress tables from many (100)remote switchs using a command line.Thank you for any helpPatrice

So... I've been running many versions of IOS on many routers and never had any problems with CBAC Firewall, NAT, public IP on the outside, private range on the inside - fairly straightforward. On this particular router, I've been running software wi...

Dear All, please give me suggestion how can i upgrade the IOS in 7513 i hv my laptop with me but i can't ..pls l;et me know the procedure.rgdscisobuddy

Hi everybody.I have catalyst 35550 (c3550-i5q3l2-mz.121-19.EA1) with configured simplest MAC access list attached to L2 interface:mac access-list extended xxx deny any any!interface FastEthernet0/2 switchport access vlan 20 switchport mode access n...

Hi,I am migrating a FDDI bridged network into a routed one, for that a 6509 with sup720 has been installed. Everything seems to be OK until i tried to browse the XDMCP servers available, none appear (it should list dozens of Unix servers).I assume t...

Hi to all,I have 4 Cisco Switch 2950C Switches to be installed in a cabinet.What type of cable do I have to use to connect each other? Please be advice.Thanks

Hi,I am wondering to find out if there is any difference in using "bgp default local-preference" in gbp config Vs using "set local-preference" under a route map.In my understanding, using set local-preference=X under route map gives local pref=x in t...