We have created a tunnel between two routers across DS-3 serial interfaces, then encrypt the data. Since the mtu of the interface can be set to over 4,000 bytes, can we set the mtu of the serial interface, the ip mtu of the serial interface, the mtu ...
All,I have an 8510csr and want to know if i can turn this into an ATM switch from a L3 switch. It has an c8510-srp and a load of 8 port 10/100 cards.I assume the chassis is the same as an MSR and all i would need is to change the switch porc card, o...
One of our clients has a central 72xx router supporting incoming and outgoing calls with a large estate of ISDN routers connecting over 4 PRI circuits. They are currently trying to implement an HSRP solution with a second 72xx router. The central net...
Hi,I need help in re-designing our LAN, which is currently based on: - 1 router (not Cisco) connected to my ISP via a 64KB leased Line. - Windows 2000 Server with Small business server, using exchange server for the mailboxes and ISA server for the ...
Recently during deployment of a Sun system, I had a system go down (Micorost system) do to IP conflict with the system that was being installed, no error on the Sun System. The systems were on the same network 172.20.207.x. but the duplicate IP addr...
Does CiscoWorks backup configurations of devices automatically once they are considered managed? I can view Compare Configs ect. And if so, how can I be sure this is taking place correctly?
I am trying to create a archive of my configurations.When I run the update I get about half the configs the others showed up as failed with the reason (null). That is a great explanation.
Please explain the benefit of running a group of Catalyst switches together via Gigastack in the setup that drops all communication to half-duplex. Doesn't this slow down overall communications and defeat the purpose??
Good Day,Does anyone know where on the Cisco web I can find a document that would describe in detail what kind of messages are being logged at each logging level (0 - 7) for IOS and CatOS? Thanks.
i received %CI-2-ENVCRIT: -12 Voltage measured at -6.43 from 7513here's the show environment output:WLM-RT7513-01#show environment allArbiter type 1, backplane type 7513 (id 2)Power supply #1 is 1200W AC (id 1), power supply #2 is 1200W AC (id 1)Acti...
Situation:DHCP-Server (W2K) in VLAN 1 (192.168.168.115/24)Router between VLAN 1 (192.168.168.1/24) and VLAN 2 (192.168.169.1/24)Secondary IP-Address-Range in VLAN 2 on Router-Interface (172.0.0.1/24)Router forwards DHCP-Requests from VLAN 2 to DHCP-...
Hi folks,I am using Ciscoworks 2000 LMS 2.2 on solaris to upgrade the firmware for all IOS switches. I found that it takes almost 2 hours to complete only 20 devices upgrade!! When I check the job report, I find that each device takes about 6min, mor...
Hello,Can I match the policy based routing with the AS number ?In my case it would be too difficult to route the traffic on a per IP address basis (matching the IP addresses) on the router2.site 1--router1-router2--VLAN1---router3site 1 advertises wi...
