Other Network Architecture Subjects

I am facing a problem while redistributing between IS-IS and OSPF. I try to explain you belowA--------B-----------CA and C has 3 Physical (2Serial and 1Fastethernet) and a loopback interface. B has only 3 Physical interfaces and no loopback interface...

We are trying an evaluation copy of SolarWinds and having trouble with some problems with MIBs. SNMP is configured correctly on the PIX (6.2.2) however we keep getting error that device does not support Cisco AvgBusy5 MIB. Can someone help me out w...

HiI have a remote 2950-24 switch that is working fine, can telnet to it etc. BUT when I try to update the confuguration archive using CiscoWorks RME the switch reboots! I have 29 other switches that do not exhibit this when RME updates.I intend to sw...

I have a LAN with 167 VLANS.My core switch is a Catalyst 6509,I have redundant Supservisory 2GE module with MSFC2.I want to configure the Switch as a DHCP server for the 150 plus VLANs.Is this possible?

Hello,A customer use a program on a server to wake up its computers.When the server is on the same subnet that computer : there is no problem.When the server is on another subnet that computer : frames are dropped by the switch layer 3.So we think th...

Sep 18, 2003, 7:26pm PST With this command: ip nat inside source static network 192.168.100.0 255.255.255.0 203.145.145.145 Is it possible for me to NAT a whole subnet of 192.168.100.0 to the external static ip address of 203.145.145.145. Eg, if I ha...

The topo just like :internet---pix---c2621(NAT-gateway)---pcNow PC can access internet , How can I block it without modify C2621's config ?(Because I have no permission)Regards

I have a Sup1A with MSFC/PFC that I have converted from hybrid to native. The conversion process went flawlessly, but when I issued the final reload to have it boot the native image automatically, I now cannot get into the console port. I get no outp...

Hi,I want to make DLSw as unintersting traffic to trigger the ISDN dial.IS below alone is enough or any additions requiredaccess-list 101 deny tcp any eq 2065 anyaccess-list 101 deny tcp any eq any 2065access-list 101 permit any anyThanks,Martin

i have big problem with switch catalyst 4006 ....with ( ws-4013 supervisor -3 modules ws-x4148-rj)without any reasons when i put any of the modules in slot 2 or slot 3 or slot 5 they give faulty status!!!! when i put modules in slot 4 or slot 6...

All of a sudden 3745 stopped processing and showed these errors when consoled in. Its memory fragmentation. IOS 12.2(15)T2. Anyone aware of an exact bug here?%SYS-2-MALLOCFAIL: Memory allocation of 276 bytes failed from 0x6049FF30, alignment 32Pool: ...

I have a trunk configured between a cisco 3508 and a cisco 3750. I checked the fiber and it is OK. The configurations are below. I have taffic in one direction only. Am I missing a comand or is there a problem to have a trunk between the two devices?...

The 'partition flash' command is not valid on the 3725 IOS. Is there a new commnd or has this very usefill capability been retired?

We have a client who uses a Cisco 1721 Router for their internet access and runs Microsoft SBS 4.5 for their server. They want to use VPN to access their office but I understand the 1721 does not support VPN. Is their a way of configuring the router ...