Other Network Architecture Subjects

hi, We have a lot of 2950-G with 25% to 30% cpu load.I found the "Calhoun LED Proc" with 9 %.Any one know what the Calhoun LED Proc means ?attached the show process cpu.best regards.fred.OFCE3-3F-20#show proc cpuCPU utilization for five seconds: 26...

Hello,I am a newcomer to DSL technologies and this is my first post in this section.My question. I know that DSL is often used as an access technology into the internet cloud. However, can any of the DSL technologies also work in a point to point ar...

I am trying to configure SNMP on 3600 series router version11.12. It is meant be be accessed through MRTG, but it has not been successful. Other cisco switches are working fine. Any suggestion will be appreciated.

Attack of blaster.worm from lan cause router's cpu utilization reaches 70%-80%, besides intalling patches on affected pcs, is there any other work around on cisco router or switch to filter such viruses?

My customer has a ubr7223, now is necesary join two upstream ports of the same blade connected to and splitter, the idea is add more than 200 users(CM) sharing the same cable. I know that is possible, but i don`t know how cable modems registration wi...

Hello all,I try to configure DDR.When using ppp chap hostname + password on the BRI interface, all is working just fine.When using the same configuration with dialer the remore router recieves Authentication failure. Is there any diff between BRI and...

I have a 6509 with a Sup1A-MSFC2 and a 6408 8 port Gigabit blade. I boot he switch up the Sup comes online then the 6408 comes online w/minorfailure. When I do a sho mod it says the 6408 is OK but I do a sho test 3 (6408 is in the 3rd slot" I get loo...

I am moving a 1600 from one application to another and I need a quick and clean (or dirty) way to wipe the config and load fresh. I know I have done this before but it has been a bad week and I am feelng stupid.

I have a AS5300 with the IOS 12.0(7)T2 and my modem firmware is 2.7.3.0. My question is when I and several people dial in we get disconnected continously. Is this a setting that needs to be adjusted. If so could someone please advise. Thanks

This can be very simple but just don't get it...I can traceroute to a neighbor router but can not ping?There is no ACL on either router; 2 routers are connect to different switches with trunk link in between.I can ping both routers from anywhere else...

I am looking for an inexpensive router firewall solution to implement on a home users network. The user has a cablemodem and I would like to set them up with a vpn from home to the office. I have a PIX 515 in the office I have vpns already running ...

Is it true that Console and AUX will utilize more cpu .RegardsMudassir.

I have problem with our Cisco switches and our Dell switches using GBIC 1000baseSX modules(All Cisco brand GBIC's). I have one 3548xl, and one 3524xl, and Four Dell 3024 switches. The Cisco IOS is 12.0(5) WC7, the newest, and so is the Dell’s firmwar...

Hello all,hopefully there is a simple answer to this question...I am setting up numerous switches and want to know if i can specify commands to multiple ports at once or do i have to enter commands for each port seperately? I am basically trying to d...