Hi. I am trying to add image to the library in CW 2k Sofware mamangement. The image I am trying to add is c3500xl-c3h2s-mz.120-5.WC5.bin. I have tried the tar version of it too and images from 2900 series switches also with no luck. The image is goo...
Ok here is how I am blocking Peer to peer network programs.. I have this is many of our remote offices and it has not proved to be a problem for clients . Now in one of our offices a client has problems with his VPN being slow and dropping connection...
Hi GuysI Have a campus with 54 edge switches, 2 cat4006 and a 6509. I am running CWLMS. Initially the CW2000 campus manager was working fine showing the correct topology with the correct IP addresses for the switches. Later on the customer requested...
I have 5 Vlans (including Vlan 1) configured on a 4507r and 3550 switches. Vlan 2-5 are configured with the cable-range and AppleTalk zone. Using a MAC computer, I am able to see the zones I created as well as access servers belonging to these Vlan...
I would like to limit the bandwidth on a 1GB Ethernetport to 200MB. Have you any solutions for me. HW description CAT 3550-12G with SW Version 12.1(12c)EA1thanks Roland Marti
Hi,I will use the "archive upload-sw" command for upload an image from the switch to a FTP or TFTP server. The switch crashed with a dump several times. Thanks for help.Hartmut
I'm using a 2509 to connect to multiple Cisco devices. The problem that I'm having is that as soon as I connect to one of the devices, I am stuck in there and cannot get out using the Ctrl-Shift-6-X combination. What's the trick?I've used both Hypert...
how could i get the arrival and departure time of a specific packet in a router using SNMP or some other kind of protocol.Should i have to configure the router for that?
Hi,Could someone provide me some helpful hint about which module to use with a SUP 720??? Is it possible to use the gigabit "classic" modules using Centralized CEF??? If yes, these module will connect direct to Backplane of the SUP720 or ONLY to the...
RME 3.4 Question: Decreasing the size of archived configurationsPrevious attempts to decrease the size of the directory in which the archived configurations were stored caused a DB restore. I don’t want this to happen again. However, the sizes of ...
Hello,on our AS5300 we have many (over 300) dialer map entries on the interfacegroup-async1. If we enter "group-range x y" we get the message above.What limitation does this hit? Any ideas?Regards, Snitram
Can I do a simple copy and paste of running config for this upgrade. I have tried and the only thing that doesnt move over is the dot1q encapsulation. The configuration doesn't work so i was wondering if i was missing something? Is there a config...
