I have a 3725& a 3745,the load of 3725 always is more than 50%,I want to know if I can add another cpu in 3525?or can I add another cpu to 3745?or 3660?thanks
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
After reset, terminal gives all garbage charactors, can't read. anyway change back to 0x2142 or 0x2102? Anyone experienced this before.? Change terminal speed if so what's the speed to read. How to get back to Romon if can't read?thanks for the help.
hello.allI have a problem with floating static routes.In my center,there is a 6509 and a 7513.In remote ,there is a 1720 with a wic-1t and a bri.all wic-1t and bri connect to 7513The wic-1t is the primary interface with hdlc that there is running osp...
We are expanding our network into the building next door using fiber. We currently have a Catalyst 5500 with the following modules-(2) WS-X5530 supervisor modules(2) WS - FEFX MMF dual port fiber modules(10) 24 port 10/100 ethernet modulesWe are look...
I am in need of assistance with an issue. We have an installation of a Novell SFT III (2-server fault tolerence) solution that is on a subnet the uses the CAT 6509 as the layer 3 device. The SFT III communicates utilizing two seperate IPs per MAC add...
I have internal network segment of 10.10.1.X and 10.10.2.X. Using W2000S as the router gateway for this 2 segments to communicate. I want to allow VPN Client Remote Access with IP Pool of 10.10.3.X to only access to 10.10.2.X LAN network. How can I a...
Show ver dosn't show the serial number:Sunset_newT3#sh verCisco Internetwork Operating System SoftwareIOS (tm) 7200 Software (C7200-IS-M), Version 12.1(14)E, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)TAC Support: http://www.cisco.com/tacCopyright (c) 19...
Hi everyone,I have some sort of strange problem.In my network I run a Port-channel between a Cisco 7513 and a Catalyst 2950-24. The Port-channel is a trunk link with dot1q encapsulation. Whenever I change the configuration of the Port-channel interfa...
Hi all,I need to replace a WIC ADSl interface on a C1721 with a 1 port Ethernet WIC.May just power down the router change the WIC and power up the router again ?Before to replace it should I erase ATM configuration ?Should I shout down the ATM 0 inte...
hello i just reloaded my ios on a 2611 router from my router software loader cd that came with the router. my question is that when i do a show version it says " C2600 Software (C2600-IO3-M), Version 12.0(5)XK1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc...
hello,i have researched on VLANs and trying to find out how many VLANs to createon a network with 200 users and about 80 servers. I have created only one user vlan and one server vlan. I can see that for a small network, having one server vlan is a...
